OEM Amana Ice Maker Parts & Accessories

CIRCULATION PUMP

$77.95

Fix Number: FIX16555298
Manufacturer Part Number: W11542868

This drain pump assembly removes leftover water from the ice maker reservoir after each cycle, helping prevent leaks and moisture buildup. It supports efficient cooling by keeping the interior dry and is a key part of maintaining proper ice production. If water is pooling or the machine isn’t performing well, replacing the pump may restore normal operation.

Grid Cutter Assembly

$153.73

Fix Number: FIX11770079
Manufacturer Part Number: W10919199

This cutter grid uses heated wires to cut ice slabs into uniform cubes before they drop into the bin. It helps improve ice maker efficiency and consistency. If your ice cubes are misshaped or not being cut, this part may need replacing. Always disconnect power and confirm model compatibility before installation.

Electronic Control Board

$271.09

Fix Number: FIX12346592
Manufacturer Part Number: W11034363

PUMP

$150.91

Fix Number: FIX16555297
Manufacturer Part Number: W11542867

The circulation pump is an essential component of select ice makers. It continuously circulates water over the evaporator plate, allowing ice to form into a solid slab before being cut into cubes. This function ensures consistent ice production for optimal performance. This replacement pump may look slightly different from the original but offers the same functionality. Before installation, disconnect the power to avoid electrical hazards. Handle the pump carefully and wear work gloves to protect your hands.

Watch the install video

Refrigerator Switch

$27.76

★★★★★

1 Review

Fix Number: FIX12584655
Manufacturer Part Number: W11291138

This is a light switch for your refrigerator. It activates when the door of your appliance is opened, and it will turn the light inside on and off. You will need to replace this part is if your light is not working properly. In order to make this repair you will need a Phillips screwdriver, a pair of needle nose pliers, and a small flat blade screwdriver. This light switch is almost 2 inches long, 1.5 inches wide, and just over an inch thick.

Fixes these symptoms

Light not working
See more...

Installation Instructions

Vernon from Halethorpe, MD

Light swithch stop working had to be replaced.

Use a flat head screw drive to pry the old switch out, remove the 2 wires and connected them to the new switch and pop the new switch back in done in 5 minutes tops. Read more...

PAN-WATER

$42.18

Fix Number: FIX16744957
Manufacturer Part Number: W11614100

Watch the install video

Condenser Fan Motor Kit

$80.15

★★★★★

2 Reviews

Fix Number: FIX1957416
Manufacturer Part Number: W10124096

This fan motor is used in frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, to cool the compressor and condenser coils. This fan motor also helps to evaporate excess water in the drain pan. This kit includes the motor, fan blade, wire harness, and screw. If your refrigerator/freezer section is too warm you may need to replace this part. This part has been updated by the manufacturer. It may look different in appearance but will still function the same as the original part. This is a genuine OEM part. Disconnect power to your refrigerator before starting the repair.

Fixes these symptoms

Clicking sound
Freezer section too warm
Fridge and Freezer are too warm
See more...

Installation Instructions

Patricia from Moline, IL

Very noisy whenever the fan came on.

Watched several online videos. Removed the fan blade, then the motor still attached to the motor mount so I could see what I was doing to attach the new motor to the motor mount. Then reinstalled the whole assembly, plugged in it's wires with the supplied adapter and attached the new fan blade. Read more...

Ice Maker Bin Temperature Sensor

$52.99

Fix Number: FIX11755842
Manufacturer Part Number: WPW10511923

This temperature sensor monitors the ice bin in select refrigerators to help regulate ice production. It sends temperature readings to the control board, preventing overfilling or melting. Compatible with models from Whirlpool, KitchenAid, Maytag, and others. Check your model before replacing.