DeWALT Table Saw Bearings

Fix Number

FIX10166797

Manufacturer Part Number

153451-00

This is available as an individual replacement part and is made of metal. The thrust bearing goes between two thrust washers and helps to reduce friction. If this part becomes broken it will need to be replaced and may require a socket set during the installation. This is an OEM DeWALT part directly sourced from the manufacturer for use in table saws and miter saws.

Fix Number

FIX10169630

Manufacturer Part Number

330003-60

This is a bearing, and it is used in various power tools. It is meant to reduce tension between the moving parts within the tool. This bearing has a 1 inch outer diameter, less than 1/4-inch inner diameter, and green walls.

Fix Number

FIX10178364

Manufacturer Part Number

5140117-81

Fix Number

FIX10178362

Manufacturer Part Number

5140117-79

Fix Number

FIX10178370

Manufacturer Part Number

5140118-21

This is a genuine DeWalt replacement part that is sourced from the original manufacturer to be used with job site table saws. The sealed bearing is commonly used to reduce friction between a fixed part assembly and a rotating shaft. This bearing is available as an individual replacement part.

Fix Number

FIX10178363

Manufacturer Part Number

5140117-80

Fix Number

FIX10177108

Manufacturer Part Number

5140033-25

Fix Number

FIX10180942

Manufacturer Part Number

605155-00

Fix Number

FIX10177012

Manufacturer Part Number

5140032-19

This is an authentic manufacturer-sourced bushing which is specially designed for use with DeWALT saws. It is an identical replacement for a missing or faulty component that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality bushing is made of durable metal and is sold individually.

Fix Number

FIX10177029

Manufacturer Part Number

5140032-36

This is an original DeWALT replacement part. The bearing block is designed by the manufacturer for use in table saws. This part is made of high-quality plastic, and is used at either end of the gear rod to allow it to move easily. You will require a wrench when replacing this item. This part is sold individually.