Alpha Tile Saw Parts

Fix Number

FIX10261486

Manufacturer Part Number

133094

This is an authentic OEM part. The water valve bracket is constructed of high-quality metal, and is compatible with several wet stone cutters. This part has been designed to help secure the water valve and nozzle to the device. The water valve bracket is sold individually. A screwdriver is necessary in the proper removal and replacement.

Fix Number

FIX10261542

Manufacturer Part Number

133495

Fix Number

FIX10261450

Manufacturer Part Number

133028

Fix Number

FIX10261455

Manufacturer Part Number

133033

This is a genuine OEM part that has been sourced directly from Alpha. This is a 2 piece set of carbon bushes commonly used in tile saws. These carbon brushes comes with wire lead and brush spring attached. Carbon bushes in your tile saw take the electricity from outside the motor and use it drive the spinning armature. Over time these carbon brushes will wear down, this is due to the amount of friction they experience. Signs your carbon brushes might be worn down are that the motor is running intermittently, there are electric breaking issues, and engine is experiencing reduced power. We recommend you replace both carbon brushes at the same time, even if only one is worn out. Before you begin this repair make sure you unplug your power tool.

★★★★★

★★★★★

1 Review

Fix Number

FIX10261511

Manufacturer Part Number

133362

This is a genuine OEM part that has been sourced directly from Alpha. Wet saws are used in cutting tile to increase the accuracy of the cuts. The water helps keep both the blade and the tile cool, this limits the risk of chipping tiles, and also increases visibility due to lack of dust created. This water valve controls the flow of water being pumped to the blade on your tile cutter. The water valve is made of metal; the handle is coated in rubber. Before you replace the water valve on your tile cutter disconnect the nylon hose from the water source, and be sure to unplug your tile cutter.

Fix Number

FIX10261551

Manufacturer Part Number

133508

Fix Number

FIX10261564

Manufacturer Part Number

133523

Fix Number

FIX10261454

Manufacturer Part Number

133032

This is a genuine OEM part that has been sourced directly from Alpha. The brush cap is mounted on the outside of the brush holder. This cap holds the carbon brush in place, while also allowing you to easily access the part for replacement. When carbon brushes wear out they can cause motor malfunction, which is why you need a way to access the brushes. The carbon brush caps are located at the rear of the motor, and there is one on each side. The caps simply screw into place. The carbon brush cap is made of plastic, and it is sold individually.

Fix Number

FIX10261456

Manufacturer Part Number

133034

A faulty brush connection can cause a cutter or saw to start poorly, stop without warning, or produce weak motor power. The brush terminal assembly forms part of the electrical path leading to the motors carbon brush. Check for heat damage, loose connections, broken wires, or worn insulation before replacement. Also inspect both carbon brushes and the armature for cracks, pitting, burning, or uneven wear. Order by the exact tool model because similar machines may use different electrical components. Disconnect the power cord and water line before service, allow the tool to dry, and note the original wire routing. Keep wires away from moving pieces when reassembling the housing.

Fix Number

FIX10261491

Manufacturer Part Number

133229