OEM Black and Decker Table Saw Parts & Accessories

Carbon Brush (Sold Individually)

$10.69

Fix Number: FIX10176277
Manufacturer Part Number: 5140011-85

This is a single carbon brush with a spring. Carbon brushes are what supply electricity to the armature. They are known to wear due to constant rubbing against the commutator, so it should not be a concern if they are in need of a replacement. They should be inspected regularly, especially if your power tool is not functioning properly. A worn brush can cause excessive sparks, however a damaged armature can also cause sparks, so you will need to inspect both parts. This is a simple repair that should only take a few minutes. You will need to remove the brush caps, and then align the new carbon brush in the holder with the tabs. You will need a screwdriver to secure the cap.

Switch W/ Key

$41.51

★★★★★

10 Reviews

Fix Number: FIX10325609
Manufacturer Part Number: 489105-00

This Switch is an OEM approved replacement part for various tools and models manufactured by Delta, Black and Decker, and Porter Cable. For full compatibility, please see the "Model Cross Reference List" below. This Switch has four terminals, a removable safety key, and a compact design for easy installation. The purpose of the switch is to turn the device on/off, as well as playing a role in electric breaking by momentarily reversing electrical polarity. Due to the mechanical internals of switches, they tend to degrade and wear out over time, making them a commonly replaced part in power tools. Common symptoms of a broken switch include: the device has completely stopped functioning, it will not turn on, and turning off intermittently during use. Each Switch is sold individually, and may also be referred to as a Rocker Switch.

Installation Instructions

keith from EMPORIA, KS

Power switch would not turn saw off

unplugged power cord.
removed the nut holding the power switch assembly on the saw.
removed 3 screws from the back cover.
removed the 2 white wires and 2 black wires from the switch terminal post. pay attention to wire color on each post.
removed old switch from the bracket by squeezing the sides of the old switch to remove the switch from the bracket.
inserted the new switch in place in the opening.
re attached the wires to the spade terminal on the switch using the 4 terminals. black on the 2 posts top and bottom on one side and the other side white on the top and bottom.
re attach the switch assembly to the table saw
test operation Read more...

Brush (Sold Individually)

$4.99

Fix Number: FIX10253754
Manufacturer Part Number: 90512443

Washer

$5.19

Fix Number: FIX10176170
Manufacturer Part Number: 5140010-69

This is a washer for your power tools. It is made of steel, and is sold individually. The washer is needed to evenly divide pressure and weight between two connected parts. It has various applications, depending on your equipment.

Key

$10.37

Fix Number: FIX10318424
Manufacturer Part Number: 1343758

This safety key fits multiple hardware tools and is inserted into the switch to make it possible for your machine to turn on and operate. Tip: you can remove the key to prevent unauthorized use of the machine. For installation instructions refer to the diagram provided by the manufacturer.

Cord/10FT./18-3

$33.30

Fix Number: FIX10169973
Manufacturer Part Number: 36480-98

Nut

$4.99

Fix Number: FIX10173255
Manufacturer Part Number: 429989-57

Nut,Hex

$4.99

Fix Number: FIX10169670
Manufacturer Part Number: 330015-03

This hex nut with internal threads, screws to the shank of a bolt or a hex cap screw in a variety of lawn and gardening tools. It can have multiple applications depending on the tool you are using. To replace, you will need a wrench to loosen and tighten the nut. For detailed installation instructions, refer to the diagram provided by the manufacturer. Remember to unplug tool from power source before beginning this repair project.