Ryobi Orbital or Palm Sander Parts

Fix Number

FIX12090308

Manufacturer Part Number

019657001016

This is an authentic part that is supplied directly from the original equipment manufacturer for Ryobi orbit sanders. The dust bag collects the dust that is created while sanding. This part is made of fabric, a metal zipper for essay clean up, and the plastic mounting bracket. There are no tools required for installation, the dust bag comes already assembled. Just slide the mounting bracket on to the body of the saw to install.

★★★★★

★★★★★

1 Review

Fix Number

FIX12090312

Manufacturer Part Number

019657001105

Fix Number

FIX10075790

Manufacturer Part Number

030157001017

This brake is a genuine Ryobi replacement part. It is commonly used in random orbit sanders. It is made of rubber and sold individually. A screwdriver is needed for replacement. To replace this part: 1. Remove the backing pad by removing the four screws. 2. Remove the top cap by extracting the retaining screws. 3. Remove the switch trigger by lifting it out of the unit. 4. Remove the retaining screws from the motor housing. Then separate the two halves and top of the housing with a screwdriver. 5. Remove the old break pad from the unit and replace it with the new pad by aligning the tabs with the grooves. 6. Reassemble the unit.

Fix Number

FIX18726545

Manufacturer Part Number

590936005

This is an OEM brake skirt for a random orbit sander, sold individually. The brake is located just above the pad. It rubs against the pad and prevents it from rotating when the sander is not touching the workpiece. Over the use of the tool, the brake skirt will wear out eventually. It will become evident that it is worn if the pad is rotating at a high RPM when the sander is not on the workpiece. This can cause a gouge when the sander first contacts the workpiece.

★★★★★

★★★★★

1 Review

Fix Number

FIX18693702

Manufacturer Part Number

300527008

Fix Number

FIX12090311

Manufacturer Part Number

019657001104

Fix Number

FIX10075787

Manufacturer Part Number

030157001014

This is an original replacement part sourced directly from the manufacturer. The washer is found in Ryobi random orbit sanders. This part is made of metal, and is used to provide a seat for the screw that secures the bearing cap assembly. You may require a screwdriver when replacing this item. The washer is sold as an individual replacement part.

Fix Number

FIX12090307

Manufacturer Part Number

019657001005

Fix Number

FIX16668487

Manufacturer Part Number

303590023

Fix Number

FIX16394813

Manufacturer Part Number

681458028