Makita Die Grinder Parts

Fix Number

FIX10156653

Manufacturer Part Number

CB340

Set of 2 Carbon Brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. rnThis brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes frequently are the cause behind a motor running poorly. • Replacing brushes can fix a motor that’s operating intermittently. • New brushes can restore a motor’s electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Fix Number

FIX10156652

Manufacturer Part Number

CB325

Fix Number

FIX10153834

Manufacturer Part Number

664064-4

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing your old cord, take note of the wire leads placements, and how they connect to the receptacle in the tool. You will have to attach the new cord similarly.

Fix Number

FIX10156669

Manufacturer Part Number

CB75

If your motor is running poorly, running intermittently, it is likely in need of new carbon brushes. This part includes a set of two carbon brushes with wire leads and brush springs attached. Changing the carbon brushes is part of your regular maintenance, so it is a good idea to have a few extra on hand. When replacing the carbon brushes, it is also advised to inspect the armature at the same time.

Fix Number

FIX10150875

Manufacturer Part Number

419566-3

This is an individually sold black switch button. The switch button is what the user presses to turn the tool on or off. It connects to the actuating lever which runs to the switch. Due to consistent use , the switch can be prone to deterioration. If the tool is not turning on, or the locked position is no longer working, it may be due to a malfunctioning switch. This OEM quality switch is the part you will need to get your tool up and running again.

Fix Number

FIX10153839

Manufacturer Part Number

664213-3

Fix Number

FIX10153514

Manufacturer Part Number

650579-7

Fix Number

FIX10141475

Manufacturer Part Number

210023-2

Fix Number

FIX10036146

Manufacturer Part Number

961052-5

Fix Number

FIX10153856

Manufacturer Part Number

664630-7