OEM Porter Cable Angle Grinder Parts & Accessories

Power Cord

$17.56

Fix Number: FIX10169875
Manufacturer Part Number: 330072-98

This power cord is used for power tools and some of the following tools: electric drills, reciprocating saws, jig saws, biscuit joiners, and routers. The power cord is made for double insulated tools and is a two-wire cord with two prongs, but it does not need a ground wire. If there are cuts in the cord insulation, intermittent power during operation, or damaged and bent prongs, then replacing the power cord will solve the problem. The tools needed for this repair are a Phillips screwdriver, small screwdriver, wire cutters/strippers, crimping tool, and terminal (ring or spade). Repair tip: During installation, remember that new cord wires must go correctly into wire terminals. Also, to avoid pinching when the tool case is put back into place, remember to route cord and wires in the right path.

Installation Instructions

John from Hancock, MI

Did not come with grinding disc guard

While unit was unplugged I screwed clamp of guard around grinder. Read more...

Wrench

$4.99

Fix Number: FIX10180699
Manufacturer Part Number: 596440-00

O-Ring

$4.99

Fix Number: FIX10182951
Manufacturer Part Number: 633044-00

Inner Flange

$5.19

Fix Number: FIX10176322
Manufacturer Part Number: 5140014-93

Watch the install video

Reliever

$6.09

Fix Number: FIX10109834
Manufacturer Part Number: 810716

This cord protector or reliever fits the end of your cord to protect the base of the cord from getting damaged and bent. If your cord is not aligned and protected it can become a safety hazard. If your cord protector is damaged or broken, then replace it as soon as possible. *Please note: this part is sold individually.