Pressure Washer Pumps

Fix Number

FIX9938134

Manufacturer Part Number

308452002

This is an OEM detergent suction kit, also referred to as a chemical injection kit, for a pressure washer. This kit is threaded into the pump assembly and is connected to the chemical siphon tube that is located in a container that holds the cleaner. This kit includes, (1) bronze nozzle, (1) large O-ring, (1) small O-ring, (1) steel ball, (1) spring (5 components total). For this repair, use a pair of pliers to grasp the detergent supply tube and remove the tube from the chemical injector. Remove the old injector with a wrench. To prepare the kit, start by placing the O-rings on the bronzed nozzle, then the steel ball, then the spring. Apply lubricant on the large O-ring and then thread it back into the port.

Fix Number

FIX12635667

Manufacturer Part Number

310924003

This part is an OEM from Ryobi. The pump unloader valve is a pressure washer component. The metal item is designed to relieve the engine from trapped air, and is sold individually. A screwdriver, needle nose pliers and a wrench set are often needed for the installation.

Fix Number

FIX18783873

Manufacturer Part Number

308653097

Fix Number

FIX18783869

Manufacturer Part Number

308653054

This is a Genuine OEM replacement part designed for use with Ryobi Pressure Washer. This item is made out of Metal and it is Sold Individually. The purpose of the Pump is to create water pressure to operate the Power Washer. There are no internal parts supplied for this pump.

Fix Number

FIX18212002

Manufacturer Part Number

8.930-514.0

This is an authentic manufacturer-sourced replacement component which is designed for use with Karcher pressure washers. The purpose of the pump assembly is to build up the pressure in the tank. Over time parts may wear out or get damaged eventually requiring a replacement to maintain peak performance. Make sure to refer to the owners manual and the diagrams of your model for the exact location and the correct installation of this assembly. Note, this high-quality metal body pump is sold individually.

Fix Number

FIX10136084

Manufacturer Part Number

38-0051

Fix Number

FIX8908285

Manufacturer Part Number

190627GS

It is a genuine OEM sourced item that is designed for Briggs and Stratton, Snapper and Troy-Built pressure washers. The manifold housing is an important component that attaches to the pump head. It houses the unloader valve, the check valves, the outlet tube and the chemical injection assembly. If the manifold housing is worn or damaged it can cause water leaks and it should be replaced to ensure the equipment is functioning properly. To determine the exact location and the correct installation of this manifold housing, refer to the appropriate diagrams of your model. You will need a screwdriver and a wrench set to perform this repair. This high-quality manifold housing is made of durable metal and is sold as an individual component.

★★★★★

★★★★★

1 Review

Fix Number

FIX9268742

Manufacturer Part Number

187879GS

This is an original replacement part sourced directly from the manufacturer. The unloader kit is commonly found in pressure washers from Briggs & Stratton. This part includes a plug made of high-quality plastic, a metal valve and spring, and two flexible rubber O-rings. You may require a wrench when replacing these parts.

Fix Number

FIX9270371

Manufacturer Part Number

207365GS

Pressure washer pump kit. If the pressure washer is leaking water, the pump may need to be rebuilt or replaced. If the pump is more than a few years old, and you use the pressure washer fairly often, replace the pump.

Fix Number

FIX18783874

Manufacturer Part Number

308653098