Husky Nailer Parts

Fix Number

FIX10076403

Manufacturer Part Number

079001001024

Fix Number

FIX10076413

Manufacturer Part Number

079002001032

This part is an OEM part. The Ryobi o-ring (5.8 x 1.9) is constructed of flexible plastic, and is designed for use in several nailers. This item is fitted between the valve plunger and the spring, absorbing the nailer pressure. A hex key is helpful in the repair. The o-ring is sold individually.

Fix Number

FIX10076414

Manufacturer Part Number

079002001033

Fix Number

FIX10076433

Manufacturer Part Number

079003001015

A genuine item which is supplied by the original manufacturer for use with Ridgid, Ryobi and Husky nailers. It is a special o-ring which is utilized to provide an air-tight seal for the driver unit, please check the appropriate diagrams of your model for the correct location and application of this hardware. Over time the material may wear out and begin to crack eventually requiring a replacement, keep in mind this high-quality rubber o-ring is sold individually.

Fix Number

FIX10076425

Manufacturer Part Number

079003001002

Fix Number

FIX10076410

Manufacturer Part Number

079002001029

Fix Number

FIX10076426

Manufacturer Part Number

079003001004

Fix Number

FIX10076411

Manufacturer Part Number

079002001030

Fix Number

FIX10076421

Manufacturer Part Number

079002001045

It is a genuine item that is supplied by the original equipment manufacturer for use with nailers made by Ryobi and Ridgid. The trigger pivot pin attaches to the tool housing. A set of pliers might be necessary during the installation of this part. This item is made out of metal and will need to be replaced if it bends or breaks. This part is priced individually.

Fix Number

FIX10076432

Manufacturer Part Number

079003001014

This is an authentic OEM sourced component which is specially made for use with Ryobi, Ridgid and Husky nailers. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase, causing low compression and a loss of power. If compression is reduced significantly, the engine will not run at all. Please make sure to check the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality piston ring is made of durable metal and is sold individually.