Craftsman Nailer Caps and Lids

Fix Number

FIX18997093

Manufacturer Part Number

P0590000200

This is a black circular exhaust cover for staplers or nailers. This exhaust cover is designed to allow you to direct the air in any direction you want. Please be advised that the flange nut needed to secure this cover is sold separately, so it is a good idea to check its condition and order it as needed. To install this part, you will need a hex key or Allen wrench.

Fix Number

FIX12425939

Manufacturer Part Number

180201

Keep your nailer or stapler feeding reliably with this magazine end cap, a durable component that secures the end of the magazine while helping to protect the internal pusher and spring assembly. It plays an important role in maintaining proper fastener alignment and helping prevent debris from entering the magazine, supporting smooth and consistent operation. A cracked or damaged end cap can lead to feeding issues and reduced performance, making replacement an effective repair. Installation typically involves removing the retaining pins, replacing the end cap, and reassembling the magazine. Refer to your tool's parts diagram or service manual to confirm the correct placement before installation.

Fix Number

FIX18997123

Manufacturer Part Number

P0770002400

This is an authentic Bostitch replacement part that has been sourced from the original manufacturer to be used with pneumatic finishing nailers. The safety cover is used to cover and prevent damage to the driver guide assembly. This item is available as an individual replacement part.

Fix Number

FIX18997424

Manufacturer Part Number

SC20515.00

Fix Number

FIX18997121

Manufacturer Part Number

P0770000240

This item has been OEM sourced to ensure a high level of quality. This deflector is intended to be used with pneumatic nailers from Bostitch. This part is used to cover the end or top of the cylinder and is used to deflect the exhaust air. This item is sold as an individual replacement part.

Fix Number

FIX18990461

Manufacturer Part Number

9R209716

This is an original replacement part manufactured for use with pneumatic nailers, or staplers. This special end cap is threaded to screw into the base of the handle, and has a threaded port for the air fitting to connect. The end cap is sealed with an o-ring, it is important to inspect the o-ring for wear, or replace the o-ring to ensure a good seal. The o-ring is available separately, the end cap is sold individually.

Fix Number

FIX18990138

Manufacturer Part Number

9R195348

Fix Number

FIX18990417

Manufacturer Part Number

9R207530

Fix Number

FIX10188506

Manufacturer Part Number

N116163

Fix Number

FIX10188915

Manufacturer Part Number

N192671