Nailer Caps and Lids

Fix Number

FIX18997093

Manufacturer Part Number

P0590000200

This is a black circular exhaust cover for staplers or nailers. This exhaust cover is designed to allow you to direct the air in any direction you want. Please be advised that the flange nut needed to secure this cover is sold separately, so it is a good idea to check its condition and order it as needed. To install this part, you will need a hex key or Allen wrench.

Fix Number

FIX12425939

Manufacturer Part Number

180201

Fix Number

FIX18997097

Manufacturer Part Number

P0590007200

This is a genuine Bostitch replacement part. The Safety Pad is attached to end of the safety to prevent the material that it is being used on from getting marred or dented by the safety arm. It is a advisable to have one or two extra pads on hand as they do have a tendency to crack and deteriorate over time.

Fix Number

FIX18990568

Manufacturer Part Number

A01267

This is a high-quality component which is designed for use with Porter Cable nailers and staplers. It is supplied from the original equipment manufacturer. The housing cap is secured in the back of a nailer to ensure a tight seal between the cylinder and the piston. If the cap is damaged or is missing, this part will provide an identical replacement. Make sure to check the diagrams for your specific model for the correct installation of the new component. This high-quality housing cap is made of durable material and is sold as an individual item. The cap is secured by four Allen screws which are sold separately. In order to perform this repair, you will need a properly sized Allen wrench which is also known as a Hex key.

Fix Number

FIX12425827

Manufacturer Part Number

175561

This is a manufacturer sourced replacement part designed for use with Bostitch nailer. This is an end cap to which the hose are connected. This tool uses a 1/4" N.P.T. male plug. This cap is made out of metal and it is sold individually.

Fix Number

FIX12455360

Manufacturer Part Number

854011

The metal compression spring is made of metal and goes between the check pawl and the door. This part is available as an individual replacement and is an OEM replacement part from the manufacturer Bostitch for use in nailers. Springs can lose their tension over time and will need to be replaced. A set of pliers and a socket set may be needed when replacing this spring.

Fix Number

FIX18990569

Manufacturer Part Number

A01269

This is an authentic replacement part manufactured for use with Porter Cable brad nailers and staplers. The special housing cap is the end cap that fits on the rear of the body and the cap includes the exhaust deflector. The special housing cap is available as an individual replacement part, please note the mounting hardware is available separately.

Fix Number

FIX18997123

Manufacturer Part Number

P0770002400

This is an authentic Bostitch replacement part that has been sourced from the original manufacturer to be used with pneumatic finishing nailers. The safety cover is used to cover and prevent damage to the driver guide assembly. This item is available as an individual replacement part.

Fix Number

FIX10156938

Manufacturer Part Number

HY00000377

This is a Makita replacement part directly sourced from the manufacturer for use in nailers. The contact top goes between the contact arm and the nose adapter. A screwdriver may be needed during the replacement of this part. It is made of metal and will require replacing if it becomes broken. This part is available as an individual replacement part.

Fix Number

FIX17093903

Manufacturer Part Number

HY00000861