Makita Biscuit Joiner Parts

Fix Number

FIX10153834

Manufacturer Part Number

664064-4

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing your old cord, take note of the wire leads placements, and how they connect to the receptacle in the tool. You will have to attach the new cord similarly.

Fix Number

FIX10153852

Manufacturer Part Number

664463-0

This power cord includes 2 prongs, 2 wires, and the gauge is 14. The measurement is 8 feet long and the type is bare wire. The cord is used on various power tools, specifically gardening and lawn equipment. With use and time, power tool cords can become frayed. If there are visible signs of wear on your cord, it is important to replace it immediately. For safety practices and installation instructions, refer to the diagram provided by the manufacturer.

Fix Number

FIX10156657

Manufacturer Part Number

CB408

This part includes two carbon brushes with wire leads and brush springs. Worn brushes are typically presented as a failed or underperforming motor. Carbon brushes are a part that commonly wears, so it is a good idea to have these on hand. They are essential for a properly running motor because they conduct electricity to the armature. For this repair, you will start by removing the first brush from the motor, using a screwdriver to remove the brush cap. Once the cap is removed, the brush can be removed. Align the new brush with the holder and then reinstall the cap. Repeat these same steps for the other brush.

Fix Number

FIX10150565

Manufacturer Part Number

417771-6

Fix Number

FIX10150875

Manufacturer Part Number

419566-3

This is an individually sold black switch button. The switch button is what the user presses to turn the tool on or off. It connects to the actuating lever which runs to the switch. Due to consistent use , the switch can be prone to deterioration. If the tool is not turning on, or the locked position is no longer working, it may be due to a malfunctioning switch. This OEM quality switch is the part you will need to get your tool up and running again.

Fix Number

FIX10156645

Manufacturer Part Number

CB203

This part includes two carbon brushes with the wire leads and brush springs attached. In order for your motor to run at peak performance, it is imperative that the carbon brushes are well-maintained. The carbon brushes are needed to conduct electricity to the armature through the commutator. Over time these brushes wear down due to the constant rubbing. They should be regularly inspected to ensure your equipment continues to run smoothly. This repair should only take a few minutes.

Fix Number

FIX10141483

Manufacturer Part Number

210033-9

Fix Number

FIX10142070

Manufacturer Part Number

214251-1

Fix Number

FIX10144086

Manufacturer Part Number

251609-3

Fix Number

FIX10142080

Manufacturer Part Number

216001-0