Official Black and Decker Hammer Drill Brushes

Brush Spring

$6.25

Fix Number: FIX10173420
Manufacturer Part Number: 445860-00

This is a brush spring and it is used in a variety of power tools. The spring applies force to the motor brush inside the motor. This will keep the brush tight along the armature. If the brush has worn down it will create heat, and the spring will lose tension. If this happens, both parts will have to be replaced.

Brush

$6.38

Fix Number: FIX10167174
Manufacturer Part Number: 176949-17

This is an OEM Manufacturer Sourced replacement part used on certain Hammer Drills. Includes One (1) Carbon Brush with wire lead attached. Please note: this brush is sold individually and most tools would use Two of these carbon brushes. It is always best to replace both brushes, even if only one is worn. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Brush

$6.25

Fix Number: FIX10169034
Manufacturer Part Number: 323660-00

Includes 1 Carbon Brush with wire lead attached. Genuine DeWalt replacement part. • Worn brushes are often the cause behind a poorly running motor. • Replacing brushes can fix an intermittently operating motor. • New brushes can restore a motor's electric braking. Carbon motor brushes are one of the most commonly replaced power tool parts. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes be sure to also inspect your armature for burns, cracks, or other damage which are indication of a larger motor problem.

Brush Plate Assembly

$10.63

Fix Number: FIX10177980
Manufacturer Part Number: 5140092-63

It is an authentic OEM supplied replacement item that is specially made for use with Dewalt and Black and Decker drills. Carbon brushes play an important role by conducting the current in electric power tools. It is a complete assembly which includes one durable plastic plate, two metal brush holders with springs and two carbon brushes with lead wires.

Brush Spring

$6.25

Fix Number: FIX10166320
Manufacturer Part Number: 149425-00

This is a genuine replacement part for DeWalt and Black & Decker hammer drills. The brush spring is used to keep the pressure on the carbon brushes to ensure a constant contact with the armature. The brushes transfer the electrical energy from outside the motor into the spinning windings in the center of the motor. This item is made of durable metal. This part is sold individually.