Generator Springs and Shock Absorbers

Fix Number

FIX9933090

Manufacturer Part Number

277-42801-23

This rod spring is an original part that is designed for use with Subaru / Robin engines commonly installed on a variety of lawn and garden equipment. The spring applies tension on the governor rod allowing it to retract. Over time it may wear out and lose tension eventually requiring a replacement. It is made of high-quality metal and is sold as an individual component. Check the diagrams for your model for the exact location and the correct installation of this rod spring. It is a simple repair that should only require pliers to remove the old part and attach the new one.

Fix Number

FIX8988822

Manufacturer Part Number

498144

This manufacturer approved recoil starter pulley is designed for lawn and garden equipment engines. The recoil starter engages the drive cup on the flywheel to start the engine when pulled. This assembly includes Plastic Pulley and a Metal Recoil Spring.

Fix Number

FIX9900113

Manufacturer Part Number

16562-ZE1-020

This compression spring is sourced directly from the original equipment manufacturer for use with Honda engines commonly installed on a variety of lawn and garden equipment. It is an important component that allows the throttle to retract. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct installation of this hardware, check the diagrams of your specific model. Keep in mind this high-quality spring is made of durable metal and is sold as an individual component. You may need a screwdriver and pliers to perform this repair.

Fix Number

FIX9893688

Manufacturer Part Number

14751-ZE1-000

This is an authentic replacement part sourced directly from the manufacturer. The valve spring is commonly found in small engines from Honda. This part is made of metal, and is used to provide tension between the inlet/exhaust valves and the rocker arms. This item is provided as an individual replacement part.

Fix Number

FIX9874490

Manufacturer Part Number

0H43470118

This is an authentic OEM part that has been sourced directly from Generac. This shock absorbing foot is made of rubber, and it is used on the frame of your generator. The feet are found on the opposite end of the frame than the wheels are. The foot helps support the generator while also reducing vibration and noise. If the foot on your generator is damaged or lost this is the replacement part you need. This shock absorbing foot is sold individually, and the screw used to attach the wheel to the frame is sold separately.

Fix Number

FIX9065582

Manufacturer Part Number

691855

Fix Number

FIX11923513

Manufacturer Part Number

0J9480A114

It is an identical replacement for a missing or a damaged spring that was installed on a new equipment. The spring applies tension on the regulating arm. Check the diagrams for your specific model for the exact location and application of this hardware. Keep in mind, this high-quality product is made of durable metal and is sold as an individual item. This authentic OEM spring is specially designed for Generac portable generators.

Fix Number

FIX9900042

Manufacturer Part Number

16561-ZE3-000

This item has been sourced from the original manufacturer and is intended to be used with small engines from Honda. The metal spring is part of the governor system. The spring is used to hold the throttle at the maximum speed when the engine is under a heavy load and when the flyweights are more relaxed. This item is sold as an individual replacement part.

Fix Number

FIX9874389

Manufacturer Part Number

0H33750181

The back spring is made out of metal. This item is priced as an individual replacement part. This is an OEM part sourced directly from the manufacturer and used in Generac generators. It might require a set of pliers to replace this item. It will need to be replaced if it becomes broken or bent.

Fix Number

FIX9065505

Manufacturer Part Number

696540

Drive-Starter