DeWALT Chop Saw Power Cords

★★★★★

★★★★★

1 Review

Fix Number

FIX10169875

Manufacturer Part Number

330072-98

This power cord is used for power tools and some of the following tools: electric drills, reciprocating saws, jig saws, biscuit joiners, and routers. The power cord is made for double insulated tools and is a two-wire cord with two prongs, but it does not need a ground wire. If there are cuts in the cord insulation, intermittent power during operation, or damaged and bent prongs, then replacing the power cord will solve the problem. The tools needed for this repair are a Phillips screwdriver, small screwdriver, wire cutters/strippers, crimping tool, and terminal (ring or spade). Repair tip: During installation, remember that new cord wires must go correctly into wire terminals. Also, to avoid pinching when the tool case is put back into place, remember to route cord and wires in the right path.

Fix Number

FIX10169913

Manufacturer Part Number

330079-98

It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 10 Feet Long

Fix Number

FIX10169655

Manufacturer Part Number

330005-01

This is a cord protector, but it is also called a strain relief, and it is used with multiple power tools. This part is made of firm rubber to protect the cords from being pulled out or exposed, which would be a safety hazard. Over time the strain relief can develop cracks and break into pieces. This part is black and 4 inches long. The smallest end has a diameter of 0.5 inches. When completing this repair tuck in all wires to avoid pinching.

Fix Number

FIX10169874

Manufacturer Part Number

330072-97

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 18 Gauge • 10 Feet Long

Fix Number

FIX10184004

Manufacturer Part Number

659204-00

This replacement cordset is specially manufactured for band saws. It is an authentic high quality Dewalt item, it is not an aftermarket imitation. If the cord is damaged it is important to replace it before continuing to use the tool. This rubber insulated cord is sold individually. Please note the cord protector is sold separately. You should only need a screwdriver to complete this repair.

Fix Number

FIX10173377

Manufacturer Part Number

444518-98

This 10 ft. power cord is a genuine manufacturer sourced replacement part that is specially produced for Black and Decker and Dewalt power tools. It is used to supply electricity from a standard U.S. outlet to the tool. One durable rubber insulated cord is included per order, please note the cord sleeve protector is sold separately.

Fix Number

FIX16685780

Manufacturer Part Number

N086776

Fix Number

FIX10170776

Manufacturer Part Number

386624-07

This is an authentic replacement part manufactured for use with DeWalt chop saws. The special cordset is a two wire cord and is used to carry electricity into the saws switch and motor. This cordset is available as an individual replacement part, please see model diagram for associative parts.

Fix Number

FIX10188204

Manufacturer Part Number

N085957

This is an original DeWalt replacement part manufactured for use with chop saws. The rubber cord protector will prevent damage to the cord at the place on the cord where the most damage can occur, where it enters the machine. The cord protector is sold individually, please see model diagram for additional parts.

Fix Number

FIX10188334

Manufacturer Part Number

N095258

This is a genuine DeWalt replacement part, it is not an aftermarket imitation. The cord set is sourced from the original manufacturer to be used with chop saws. The two wire cord is used to carry electricity to the saws motor switch and motor assembly. This cord set is available as an individual replacement part.