Base Plate Trim

1. remove six phillps head screws from the outermost edge of the black under pan. (3 on each side) these are very tiny, you should use a magnetic tip on the screw driver as you support the pan. the pan will now swing down. from the front. Now disconnect the light switch wire by scweezing the connector. Now remove the pan from the micro ... Read more . remove the slide assembly (6 small screws} that secure it to the pan. to access the plastic cover, extend the slide assembly, remove the two filters that are that are secured by four small screws. to get at the push cover you will need a long phillips screwdriver as the three screws that secure the push cover have a deep angled access. remove these screws and replace the two black plastic end supports into your new cover. now reverse the procedure and you"re done. i recommend someone to help position and hold the pan in place as these are very small screws and use a magnetic tip screw (I LOST ONE IN THE STOVE)

It is a bit difficult but make sure you should have two magnetic Phillips screw driver. One with long shaft min. 12 inch long. otherwise screw out remove part and screw in. That's it.