Have you ever purchased from us before?
Thank you for helping make our site better.
Manufacturer #: WB24X830 /
Manufactured by: GE /
Fix #: FIX237422
Manufacturer #: WB24X830 |
Manufactured by: GE |
Fix #: FIX237422
removed the surrounding casing,the charcoal filter cover, and the control fixer, when all I had to do was remove the filter cover and fixer for the door switch.
Were these instructions helpful?
Replaced all three door switches even though it was only one that was bad (secondary door switch). Was easy to identify after removing the switch. It did not click and was obvious that it was broken. $60 repair rather than $20 but should not have to worry about any of the door switches for many years. After removing the screws for the sides/top and removing, removed the wires to the switches using long nose pliers, removed the 2 star shaped screws inside the door holding the switch bracket and carefully removing for easy access of switches. Easy as pie!
I unplugged the cord from wall outlet, so I would not get shocked. I unscrewed the two screws from above the door, and took off the bracket. Then, above the buttons was one screw holding it to the microwave. Remove screw and pull up on the buttons piece, and it comes lose. I let it hang. I unscrewed the door switches bracket (2 screws) and it came lose. I took The secondary door switch and monitor switch (look at both switches very carefully, there is a difference, where the wires attach to the switches.) are on the bottom(middle,and bottom.) and put back together in reverse order. All done! If by chance you open the door and turn table does not work. Replace the fuse behind the button piece. It works!!! All done
Open the door, remove the vent diffuser by removing the top two exposed screws. Remove the control panel by removing one screw now exposed from the removed diffuser, pull up on the control board to unseat, then remove the ground screw that keeps it tight to the switches so you can work more easily. The three door switches are easily accessible. Remove the two screws holding the latch bracket, pu the bracket out that's holding all the switches. Remove and replace the switches, then reassemble the microwave in reverse order.
One-third of the produce grown globally is wasted due to throwing…