Belt-secondary 47.10 37X66MA

This is a Genuine Manufacturer Approved replacement Belt used on Murray Lawn Tractors. This part is made out of Rubber and it is Sold Individually. This is the the Smaller Belt that drives Blades on your unit. Clean pulleys before installing the new belt to ensure top performance and longevity with your new belt. Inspect belt periodically and replace it when worn or stretched to maintain peak performance. You would need a Wrench set and Pliers to replace this belt. • For your safety make sure to disconnect the spark plug wire. • Fist you would need to lower the mower deck to the lowest position • Then move the blade engagement lever to the Off position. • Roll the belt off the engine pulley from between the belt guide and pulley. • Remove mower deck by removing the bow-tie pins securing the left and right lift arms • Disconnect the blade engagement cable from the mower deck • Remove the bolts from the mower deck belt pulley covers and pull the covers off. • Loosen but don't remove the nuts on the top of the idler pulleys. • Install the new mower deck belt through the belt guides and around the pulleys. • Tighten the nuts on the top of the idler pulleys. • Re-Assemble the Deck