Water Pump Engines

Fix Number

FIX9177819

Manufacturer Part Number

A101000000

This piston ring is an authentic manufacturer approved replacement part. Is is commonly used on Echo gas trimmers/edgers. The purpose of a piston ring is to create an air tight seal inside the cylinder. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase. This would cause low compression and a loss of power. Replacing an o-ring should resolve this issue. This part is made out of metal and is sold individually. To complete this repair you will need a set of wrenches, pliers and a screwdriver. • Remove the air cleaner • Drain the fuel • Remove the air cleaner case • Remove the carburetor • Remove the intake insulator • Remove the spark plug • Remove the engine cover • Remove the insulator gasket • Remove the starter assembly • Remove the fuel tank • Remove the air duct • Separate the engine • Bind the engine • Remove the clutch • Remove the flywheel • Remove the starter pulley • Unbind the engine • Remove the muffler • Separate the cylinder from the crankcase • Remove the piston ring • Install the piston ring • Reassemble and test the equipment

Fix Number

FIX9899944

Manufacturer Part Number

16555-ZE1-000

This is an OEM Honda part directly sourced from the manufacturer for use in small engines. The governor rod hooks to the governor arm. You may need a wrench and a set of pliers when replacing this part. This item may become broken or bent and will need to be replaced. It is made of metal and is available as an individual replacement part.

Fix Number

FIX9899945

Manufacturer Part Number

16555-ZE2-000

This is an original replacement part sourced directly from the manufacturer. The governor rod is commonly found in Honda small engines. This part is made of metal, and is attached to the governor arm. You may require pliers when replacing this product. This item is sold as an individual replacement part.

Fix Number

FIX11878552

Manufacturer Part Number

45-80-0110

Fix Number

FIX11889508

Manufacturer Part Number

13010-Z4M-801

Fix Number

FIX9254790

Manufacturer Part Number

10000048732

This piston kit is used to repair or rebuild small 2-stroke engines, helping restore proper compression and engine performance. Typically including the piston, rings, and retaining components, it’s a direct replacement for worn or damaged internal parts and is commonly installed during top-end engine service to correct power loss, hard starting, or low compression.

Fix Number

FIX9255054

Manufacturer Part Number

10101106562

Fix Number

FIX9886734

Manufacturer Part Number

13010-Z4M-003

Fix Number

FIX9888564

Manufacturer Part Number

13200-ZM7-800

Fix Number

FIX9899943

Manufacturer Part Number

16555-ZE0-000

The governor rod is made of metal. It is an OEM from Honda for use in engines. This part is sold individually. A set of pliers may be required to replace this part. This item might bend or break over time and will need replacing.