Official Echo Water Pump Engines

Piston Ring

$8.75

Fix Number: FIX9177819
Manufacturer Part Number: A101000000

This piston ring is an authentic manufacturer approved replacement part. Is is commonly used on Echo gas trimmers/edgers. The purpose of a piston ring is to create an air tight seal inside the cylinder. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase. This would cause low compression and a loss of power. Replacing an o-ring should resolve this issue. This part is made out of metal and is sold individually. To complete this repair you will need a set of wrenches, pliers and a screwdriver. • Remove the air cleaner • Drain the fuel • Remove the air cleaner case • Remove the carburetor • Remove the intake insulator • Remove the spark plug • Remove the engine cover • Remove the insulator gasket • Remove the starter assembly • Remove the fuel tank • Remove the air duct • Separate the engine • Bind the engine • Remove the clutch • Remove the flywheel • Remove the starter pulley • Unbind the engine • Remove the muffler • Separate the cylinder from the crankcase • Remove the piston ring • Install the piston ring • Reassemble and test the equipment

Piston Kit

$80.16

Fix Number: FIX9254790
Manufacturer Part Number: 10000048732

This piston kit is used to repair or rebuild small 2-stroke engines, helping restore proper compression and engine performance. Typically including the piston, rings, and retaining components, it’s a direct replacement for worn or damaged internal parts and is commonly installed during top-end engine service to correct power loss, hard starting, or low compression.