Select Your Echo Water Pump Model

This part is the replacement air filter for your small engine, used for outdoor power equipment. It has a black plastic rim that is approximately 2.5 inches by 2.5 inches. The air filter in your small engine prevents dirt and debris from entering the cylinder, where it can cause more serious damage. If your air filter is clogged, it can decrease your engine performance, and it will need to be cleaned or replaced. If the filter is damaged, it will need to be replaced as well. This is an OEM part sourced directly from the manufacturer, and is it sold individually.

This is a fuel line grommet, and it is used with various lawn and garden equipment. This part prevents leaking fuel and fumes. The grommet is placed in the fuel tank to seal the opening area where the fuel line and the fuel tank connect. A worn grommet is a safety hazard because it will cause fuel to leak from the tank. We recommend when replacing it to also replace the fuel line. Before starting this repair make sure to drain the fuel from the tank, and remove the spark plug.

This check valve or the fuel tank vent is connected to the fuel tank in the following products: hedge trimmer, leaf blower/vacuum, chainsaw, edger, engine, tiler, auger, water pump, chipper shredder, sprayer, and brush cutter. The check valve allows air into the fuel tank to prevent vacuum when the fuel is being fed through the fuel line. Tip: if the vent is clogged, your engine may stall. Usually, the vent line is connected to a fuel grommet that is installed on the fuel tank. The tools needed for this installation are: needle-nose pliers and a small slotted screwdriver. Remember to wear work gloves to protect hands. Refer to the manual for an accurate repair guide.

This is a fuel return tube, for various lawn equipment. This part is yellow and is 90mm long. The tube is used to return the extra fuel back into the fuel tank. This happens after the primer bulb has primed the carburetor to start. Depending on usage, this part will weaken and crack, that is when you will need to replace it.

This is a vent tube, also known as a fuel pipe, and it is for various lawn equipment. This tube works as a vent by letting air into the fuel tank to avoid a vacuum effect. The vent tube is connected to the fuel line grommet. This part is 70mm long and has a diameter of roughly 5mm.

This nut is used for a variety of handheld gardening tools. The nut has multiple applications depending on the tool you are using. Refer to the diagram provided by the manufacturer for installation instructions and nut location in a specific tool. This lock nut is used to resist loosening when threaded onto a bolt. *Please note: this part is sold individually. The measurements are: 5mm.

This is a spark plug for your lawn equipment. It ignites the mixture of air and fuel in the cylinder to power your engine. If your machine is running roughly, or not at all, the most common fix is to change the spark plug. If the tip of the plug is burnt or damaged (fouled) you will need to replace it. This part is BPM7A.This means the thread diameter is 14mm, thread reach is 9.5mm, seat type is flat, hex size is 19mm, tip configuration is projected, it is special design, and removeable.