OEM Makita Trimmer Parts | Expert DIY Repair Help & Fast Shipping

$2.99

Retaining Ring S-12

Fix Number FIX10036146

Manufacturer Part Number 961052-5

$4.27

Primer Pump

Fix Number FIX9953565

Manufacturer Part Number 424314-7

$14.08

Gasoline Filter

Fix Number FIX10140524

Manufacturer Part Number 163447-0

$4.27

Terminal

Fix Number FIX10153397

Manufacturer Part Number 643852-2

This part includes one genuine battery terminal for a cordless drill. This part is where the battery terminals connect. It is a plastic block that has metal spades, which engage the contacts on the battery. If the battery shorts or the drill overheats, this can cause damage to the terminal. If you notice melted plastic around the spades or the spades themselves have melted or are discolored, these are also signs that a replacement is required. The wire connections are another area to take note as these can cause issues with the terminal too. For this repair, remove the rear cover, separate the housings, and slide the terminal out. Be sure to take note of the wire connections and disconnect them from the terminal assembly.

$9.94

Carbon Brush Set CB-408 6x9mm

Fix Number FIX10156657

Manufacturer Part Number CB408

This part includes two carbon brushes with wire leads and brush springs. Worn brushes are typically presented as a failed or underperforming motor. Carbon brushes are a part that commonly wears, so it is a good idea to have these on hand. They are essential for a properly running motor because they conduct electricity to the armature. For this repair, you will start by removing the first brush from the motor, using a screwdriver to remove the brush cap. Once the cap is removed, the brush can be removed. Align the new brush with the holder and then reinstall the cap. Repeat these same steps for the other brush.

$19.74

Power Cord

Fix Number FIX10153834

Manufacturer Part Number 664064-4

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing your old cord, take note of the wire leads placements, and how they connect to the receptacle in the tool. You will have to attach the new cord similarly.

Installation Instructions

John from Hancock, MI

Did not come with grinding disc guard

While unit was unplugged I screwed clamp of guard around grinder. Read more...