Tiller Hardware

Fuel Line Grommet This is a fuel line grommet, and it is used with various lawn and garden equipment. This part prevents leaking fuel and fumes. The grommet is placed in the fuel tank to seal the opening area where the fuel line and the fuel tank connect. A worn grommet is a safety hazard because it will cause fuel to leak from the tank. We recommend when replacing it to also replace the fuel line. Before starting this repair make sure to drain the fuel from the tank, and remove the spark plug.

Nut, Hex, Flangelock This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most models require three. For this repair you will need a wrench set.

Clip

Wing Bolt

Key-Flywheel

Fuel Line Clamp This and an authentic OEM replacement part sourced directly from the manufacturer. Fuel line clamps are used in small engines such as snow blowers, lawn mowers, tillers, and lawn tractors. Fuel line clamps are in place to ensure the fuel line is securely attached to the carburetor. It is important that your fuel line clamps are functioning properly; having a secure fuel line prevents fuel leaks in your engine. This part is made of metal. You will require pliers to install and secure tube clips.

Cotter Pin

Nut-Hex 5/16-18 This nut is mostly used in lawn tractors and snow blowers and is in different locations in the machine, depending on appliance. It is made from metal and measures to 5/16 inches for the diameter and a thread count of 18. Tip: Remember there are different nuts used in the machine, be sure you are ordering the correct part. The tool needed for this repair is a wrench. *Please note: this part is sold individually. Refer to the diagram provided by the manufacturer for instructions.

Clamp-Hose

Nut 5 This nut is used for a variety of handheld gardening tools. The nut has multiple applications depending on the tool you are using. Refer to the diagram provided by the manufacturer for installation instructions and nut location in a specific tool. This lock nut is used to resist loosening when threaded onto a bolt. *Please note: this part is sold individually. The measurements are: 5mm.