Lawn Tractor Accessories Hardware

Fix Number

FIX9096195

Manufacturer Part Number

714-04040

This bow tie cotter pin fits snow blowers, as well as other gardening tools. The pin helps secure the auger to the shaft on a snow blower. Due to constant wear, this is a commonly replaced part. Tip: Extra pins are recommended. *Please note: this part is sold individually. For installation instructions, refer to the diagram provided by the manufacturer.

Fix Number

FIX16381792

Manufacturer Part Number

596040501

Fix Number

FIX9092936

Manufacturer Part Number

712-04063

This nut is fit for lawn and garden equipment and is used to resist loosening when properly threaded onto a bolt. The nut is sold individually. The diameter of the nut is 5/16 inches and the thread size is 18. Refer to the manual provided by the manufacturer for repair instructions.

Fix Number

FIX9052921

Manufacturer Part Number

65-2720

Fix Number

FIX10001568

Manufacturer Part Number

710-0451

This carriage bolt fits a variety of tools and is sold individually. The square area under the head of the bolt is created to fit into a square hole in your tool. The hole makes sure to restrain the bolt and prevents it from turning when the nut is secured or tightened.

Fix Number

FIX16381824

Manufacturer Part Number

596134901

Fix Number

FIX9095080

Manufacturer Part Number

712-04065

This lock nut is used for lawn and garden equipment, and is sold individually. This nut resists loosening when it is correctly threaded onto a bolt in your tool. The measurements are: the diameter of the bolt hole is 3/8 inches and the thread count is 16. For instructions on where the lock nut is located in your tool refer to the manual provided by the manufacturer.

Fix Number

FIX9310468

Manufacturer Part Number

925-1745A

Fix Number

FIX16381888

Manufacturer Part Number

596238701

Fix Number

FIX9299574

Manufacturer Part Number

712-04064

This is a flange lock nut, and it is used with various outdoor tools and equipment. The flange lock nut is all one piece. It has a bottom circular flange and a smaller top hex section. This is a torque type lock nut, and it has no temperature or chemical restrictions. This part has a 1/4-inch diameter and 20 thread size.