Weed Eater Lawn Mower Hardware
Start With Your Model Number
Popular Weed Eater Lawn Mower Hardware
Washer Head Screw
Fix Number FIX9982804
Manufacturer Part Number 584953901This part is the replacement washer head screw for your lawn tractor. It is black in color and is approximately an inch and a half in length. This self-threading screw is most commonly used for securing the mandrel housing to the mower deck of your lawn tractor. The main reason you would need to replace this part is if the old screw is damaged or missing. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.
Washer 25/32 x 1-1/4 x 16 Ga.
Fix Number FIX9008998
Manufacturer Part Number 532121749This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.
Ring Klip Number T5304-75
Fix Number FIX9143890
Manufacturer Part Number 812000029This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.
Nut, Hex, Flangelock
Fix Number FIX9022497
Manufacturer Part Number 532409149This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most models require three. For this repair you will need a wrench set.
Bolt and Washer Assembly
Fix Number FIX9020856
Manufacturer Part Number 532193003This manufacturer-approved bolt and washer assembly is for lawn tractors. Wear work gloves to protect your hands when installing this part.
Pin Cotter 7/16 Bow Tie Lock
Fix Number FIX9020881
Manufacturer Part Number 532194209This is an OEM bowtie cotter pin for lawn tractors. It is sold individually. This part is made of metal material, so over time, this metal can corrode or rust, especially if the lawn tractor is exposed to elements on a regular basis. It should be checked regularly and replaced every so often. Before you begin this repair, the ignition switch needs to be turned off, the key removed, the mower deck should be in the lowest position, and the clutch actuator lever needs to be off. When installing the new pin, make sure the washer is in place before sliding the pin into position. This repair should only take a few minutes.
Fix Number FIX9286886
Manufacturer Part Number 532187690This is an OEM lawn mower deck mandrel spacer washer, sold individually. It measures approximately 43/64-Inches in diameter, 1-1/8-Inches outer diameter, and 5/32-Inches thick (these measurements are approximate). In general, washers help to spread load, can provide insulation such as electrical, and can also help to prevent galvanic corrosion.
Pin Cotter 5/16 Bow Tie Lock
Fix Number FIX9016072
Manufacturer Part Number 532194208This is a 5/16-inch metal cotter pin and it is sold as an individual part. Cotter pins secure a variety of different assemblies by placing them through a drilled hole in a shaft or bolt, such as on a wheel on a lawn tractor. If your cotter pin is missing or damaged this authentic OEM part is designed to replace the original.