Engine Valves

Fix Number

FIX10375230

Manufacturer Part Number

610-1032

This is the discharge valve assembly for a variety of pumps. This OEM valve assembly does not come with the pump head, but features a retaining clip, spring, valve disc and valve bumper, all of which measure approximately 1-inch in diameter. Over time, valves can collect debris or corrode, and with normal wear and tear, they can get damaged, leak, or restrict the flow of fluid through the pump. If your pump is leaking on/around the discharge valve, or if the pump has higher pressure or a low flow rate, this discharge valve would be worth inspecting to see if it needs replacing. Replacing this assembly is easy and requires you to first power off the pump and disconnect the pump head and gasket. You can then remove the old assembly and install the new one. It is recommended that you replace the gasket at this juncture as well, but it is not mandatory. With the new assembly installed, reinstall the pump head and test your pump.

Fix Number

FIX9289905

Manufacturer Part Number

576618101

The valve fuel check fits between the hose clamp and the grommet check valve. This is an authentic part from Husqvarna, Poulan, and Jonsered for use in zero turn lawn mowers. It is sold individually and is made out of plastic. A set of pliers and a socket set might be helpful during the installation of this part. This part may break and will need to be replaced.

Fix Number

FIX12139644

Manufacturer Part Number

78110-YB3-000

Fix Number

FIX9145774

Manufacturer Part Number

845907

This is a geniune OEM part. The Briggs & Stratton, 10-16 amp voltage regulator is composed of metal, wiring and plastic parts. The regulator is compatible with many lawn and garden machines. This part is connected to the engine's terminals, and has been designed to manage the voltage in the device's electrical system. A screwdriver and a socket set are needed in making the removal and repair. It is recommended to refer to the manual and diagrams for repair instructions. This item is sold individually.

Fix Number

FIX9068630

Manufacturer Part Number

698180

This is an authentic OEM sourced part that is intended to be used with small engines from Briggs & Stratton and Toro. The shut-off valve attaches to the bottom of the fuel tank and is used to link the fuel line and to control the flow of fuel that goes to the engine. This item is available as an individual replacement part.

Fix Number

FIX9068632

Manufacturer Part Number

698183

This is a genuine OEM part that is intended to be used with lawnmower engines from Briggs & Stratton, Toro, and Murray. The valve attaches to the incoming fuel line and is used to regulate the flow of fuel that enters the engine. This item is available as an individual replacement part.

Fix Number

FIX9278046

Manufacturer Part Number

394681

The float valve is used to allow fuel into the float chamber when the chamber has been drained and to stop fuel from entering the chamber when it is full. It provides an identical replacement for a missing or a faulty component that was installed on a new unit. This authentic part is supplied by the original equipment manufacturer for use with Kawasaki engines commonly installed on lawn and garden equipment. Please make sure to refer to the appropriate diagrams of your model to ensure the correct repair procedure. Keep in mind this high-quality valve-fuel inlet is sold as an individual item.

Fix Number

FIX9908452

Manufacturer Part Number

176-64-1

This is a genuine Walbro replacement part. The primer check valve is found underneath the primer bulb it helps the fuel to flow in one direction, and allows the primer bulb to fill with fuel. Due to constant contact with fuel the check valve can deteriorate over time. If the check valve starts to break apart, or gets clogged the fuel will not flow into the carburetor properly, the primer bulb wont be effective, and the engine will be difficult to start, if it starts at all. The primer check valve should be replaced at the same time as the primer bulb.

Fix Number

FIX9270662

Manufacturer Part Number

21066-7017

This part is available individually. The voltage regulator attaches to the lead wire. A screwdriver might be required during the replacement of this part. It will require replacing if it becomes broken. This authentic item is supplied directly from the original equipment manufacturer for use with Kawasaki engines.

Fix Number

FIX9930297

Manufacturer Part Number

2546203-S