Official Craftsman Engine Valves

Valve Fuel Check

$26.35

Fix Number: FIX9289905
Manufacturer Part Number: 576618101

The valve fuel check fits between the hose clamp and the grommet check valve. This is an authentic part from Husqvarna, Poulan, and Jonsered for use in zero turn lawn mowers. It is sold individually and is made out of plastic. A set of pliers and a socket set might be helpful during the installation of this part. This part may break and will need to be replaced.

Lawn Mower Air Valve

$6.51

Fix Number: FIX9311038
Manufacturer Part Number: 934-0255

The air valve attaches to the wheel and is made of a durable material. This is a genuine MTD, Ryobi, Yard Machines, Bolens, Troy-Bilt, and Yard Man part sourced directly from the manufacturer for use in chippers, shredders, cultivators, edgers, lawn tractors, snowblowers, and trimmers. Keep in mind that this part is sold individually. When replacing this item a set of pliers might be required during the installation process. It might wear out over time and will need replacing.

VALVE COVER GASKET

$14.81

Fix Number: FIX18474453
Manufacturer Part Number: 751P11565B

Regulator

$79.61

Fix Number: FIX9306828
Manufacturer Part Number: 794360

This authentic manufacturer-sourced 5-9 amp regulator is made for Briggs and Stratton engines that are commonly installed on a variety of lawn and garden equipment. It is an identical replacement for a missing or a damaged component that was installed on a new unit. Refer to the owner's manual and the appropriate diagrams for your model to ensure the correct repair procedure. It is sold as an individual item. A screwdriver and pliers might be needed to replace this component.

Valve Stem

$9.02

Fix Number: FIX9069397
Manufacturer Part Number: 7012234SM

This is an OEM part sourced directly from the manufacturer. This part is used in the wheels/tires of many Murray lawn tractors and snow throwers. It allows air to be pumped in to inflate the tires, then automatically closes and is kept sealed by the pressure in the chamber, preventing the air from escaping. The part is made of a plastic housing holding a metal valve, with a threaded plastic cap. To replace this part, you will need to disconnect the tire from the rim to access the inner part of the rim. Push the old valve stem through from the outside, then insert the new part from the inside. You may want to apply some form of lubricant to the new valve stem to make it easier to push into place.