Simplicity Engine Parts

Simplicity Appliance Parts

Popular Simplicity Engine Parts

Engine Oil Seal
$7.65
In Stock
Fix Number
FIX9277860
Manufacturer Part Number
391086S
This is a genuine OEM sourced replacement part designed for use with a variety of lawn and garden equipment. This item fits the cylinder and helps to provide an air tight seal to prevent any leaks. It is made out of rubber and it is sold individually. You will need a wrench set to complete this repair.
Engine Dipstick Tube Seal
$10.95
In Stock
Fix Number
FIX9274579
Manufacturer Part Number
281370S
This item is a genuine replacement part that has been OEM sourced and is intended to be used with lawnmower engines from Briggs & Stratton and Toro. The rubber seal is used to prevent oil from leaking at the connection between the bottom of the oil fill tube and the crankcase. This item also allows the fill tube to firmly sit into the case. The dipstick tube seal if available as an individual replacement part.
Key-flywheel
$6.51
In Stock
Fix Number
FIX8925657
Manufacturer Part Number
222698S
This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Pliers to replace this item.
Switch-rotary
$27.45
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX9074729
Manufacturer Part Number
692309
This on-off switch fits Briggs and Stratton engines. This is a genuine part supplied from original manufacturer. This switch controls the on-off function of the engine. It has a plastic knob with metal terminals and is sold individually. To complete this repair you will need a wrench to remove housing.
Kit-carb Overhaul
$38.45
In Stock
Fix Number
FIX8960042
Manufacturer Part Number
394693
An engine that surges, stalls, or will not stay running can have dirt or worn seals inside its float carburetor. This rebuild kit contains gaskets and small service pieces for restoring the carburetor rather than replacing the complete unit. Inspect the fuel supply and ignition system first, then confirm the engine identification and carburetor design. Work only on a cool engine in a ventilated area. Drain all fuel, disconnect the spark plug wire, and keep sparks and cigarettes away. Photograph the linkages, clean passages without enlarging them, install each gasket in the correct order, and check carefully for leaks before starting the engine.
Spring-governor
$7.31
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX9138283
Manufacturer Part Number
796260
The governor spring is made out of metal and helps to control the speed of the engine. This authentic item is supplied directly from the original equipment manufacturer for use with Briggs & Stratton generators and Toro snowthrowers, tillers, and blower-vacuums. If it becomes lost or broken it will need to be replaced. A nutdriver may be necessary to help replace this part which is sold individually.
Line-fuel
$15.25
In Stock
Fix Number
FIX9140673
Manufacturer Part Number
791745
An authentic OEM replacement fuel line that is specially produced for use with gas powered endings commonly installed on generators and other equipment. The fuel line is used to deliver the fuel from the tank into the carburetor. Over time lines may become brittle and may crack eventually requiring replacement. This item is made from durable rubber material and it is sold individually.
Clutch-starter
$48.35
In Stock
Fix Number
FIX8968281
Manufacturer Part Number
399671
Hard starting may come from the recoil system instead of the carburetor or spark plug. If the rope pulls but the engine does not turn, the starter clutch may be worn, dirty, or jammed. The clutch turns the crankshaft during starting and lets go when the engine runs. First inspect the rope, rewind spring, pulley, flywheel screen, and clutch bearing. Confirm fit with the complete engine number. Remove the spark plug wire, wait for hot parts to cool, and keep dirt out of the bearing area. Test free movement before putting the shroud back on.
Pulley-starter
$17.55
In Stock
Fix Number
FIX8942071
Manufacturer Part Number
295871
Difficulty pulling the starter rope or a cord that stays extended can result from a damaged recoil pulley. This wheel guides and stores the rope while helping turn the engine during starting. Similar symptoms can come from a frayed rope, seized engine, bent starter housing, broken pawls, or weak return spring, so check those items first. Match the replacement to the full engine model, type, code, and equipment model. Work on a cool engine with the spark plug lead removed. Release spring tension slowly and keep your face and hands clear of the starter housing. Route the rope correctly, confirm smooth return, and reinstall every guard before starting the engine.

Installation Instructions

Robert from BROOKSIDE, UT
No instructions
No instructions on how to get the pull cord in the wind up position. Read more...
Engine Filter
$6.51
In Stock
Fix Number
FIX9275043
Manufacturer Part Number
298090S
This is a genuine OEM sourced replacement part, it is made out of plastic with filter material inside. It is sold individually and is used on a variety of lawn and garden engines. This is an fuel filter for engines with a fuel pump which makes sure that the fuel delivered to the engine is free of any debris or contaminants. It will over time become clogged and restrict the fuel getting to the engine so it will need to be replaced.

Simplicity Engine Appliance Types

Related Simplicity Engine Parts

Popular Simplicity Engine Models