Briggs and Stratton Engine Carburetors

Carburetor Overhaul Kit This is a replacement carburetor overhaul kit for your small engine. The carburetor is essential to the overall performance of your engine, and the carb can get clogged up over time for a variety of reasons. When your carb becomes clogged, it is often a good idea to take it apart and replace the various parts inside by purchasing a carburetor kit. This is a 15-piece set and contains everything that you will need to do a total overhaul of your carburetor. You may want to purchase some carb cleaner as well, to ensure that the new pieces in the carb kit fit and adhere properly.

Carburetor Rebuild Kit This is the replacement carburetor kit for your small engine, used for outdoor power equipment. The carburetor rebuild kit includes the float, needle, gaskets, and seals that you need to refurbish your carburetor. The carburetor is essential to proper engine performance so if it is dirty or damaged, it is recommended that you repair it using one of these carb kits. If basic adjustments to your carburetor will not fix your engine issues, it is an indication that you should repair the carburetor with this kit. The parts included in this kit are OEM parts sourced directly from the manufacturer.

Diaphragm-Carburetor

Primer-Carburetor (7/8"Dia. Fits BS Quantum Engines 5, 5.5 &6 HP This is an OEM primer bulb and clip. It is attached to the engine air filter base. When the primer bulb is pushed, this fills the carburetor with fuel, making it easier to start a cold engine. This rubber primer bulb is known to harden and crack over time. For this repair you will start by removing the motor cover, air filter cover, air filter, and then the primer base. You will then use a screwdriver to release the clip holding the primer bulb in place. To install the new primer bulb, place the new clip so the ears are facing out, and then line the ears up with the openings on the base. You will then use your screwdriver to help snap it into place.

Kit-Needle/Seat

Diaphragm-Carburetor This part includes one manufacturer-sourced carburetor diaphragm. A working diaphragm is an essential component of the engine, as it creates an airtight seal, needed for optimal engine performance. This diaphragm is exposed to fuel, and over time this can cause it to harden and break down. Equipment that is left for long periods of time with fuel sitting it, can speed up that deterioration.

Bowl-Float

Diaphragm-Carburetor

Primer-Carburetor

Carburetor This is an Authentic OEM replacement part used on Lawn and Garden Engines. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won\'t start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. This Assembly includes a Metal Body Carburetor, Rubber O-Ring and a Gasket. When replacing Carburetor it is advised that you also replace Carburetor Gaskets to ensure proper Air Tight Seal for optimum performance. You will need a Screwdriver to perform this repair.