Echo Chipper Shredder Parts

Primer

Spark Plug Bpm-8Y Replacing the spark plug should be part of your regular maintenance. How often to replace it depends on your model but is generally changed at least once a year or more, depending on use. When a spark plug has gone bad this can lead to a hard-starting engine, a misfire, or the engine not starting at all. Replacing it is very easy. Start by gapping your new spark plug according to the manufacturer specifications. For this repair, start by removing the boot from the old plug, use a wrench to remove it, and twist it off with your hand. Now thread the new replacement spark plug into place and tighten it using the wrench. This manufacturer-approved spark plug is sold individually.

Fuel Filter This is a single OEM fuel filter that has been approved by the manufacturer, ensuring the highest quality. It is compatible with numerous types of outdoor power equipment, such as blowers, trimmers, edgers, chainsaws, etc. This is a very important maintenance part that should be replaced on a regular schedule. Its purpose is to remove contaminants that could clog up the carburetor, which should also be regularly inspected. For this simple repair, slide the new fuel filter onto the fuel line and use a screwdriver to place the clamp tightly over the nipple.

Air Filter This part is the replacement air filter for your small engine, used for outdoor power equipment. It has a black plastic rim that is approximately 2.5 inches by 2.5 inches. The air filter in your small engine prevents dirt and debris from entering the cylinder, where it can cause more serious damage. If your air filter is clogged, it can decrease your engine performance, and it will need to be cleaned or replaced. If the filter is damaged, it will need to be replaced as well. This is an OEM part sourced directly from the manufacturer, and is it sold individually.

Fuel Tank Vent This check valve or the fuel tank vent is connected to the fuel tank in the following products: hedge trimmer, leaf blower/vacuum, chainsaw, edger, engine, tiler, auger, water pump, chipper shredder, sprayer, and brush cutter. The check valve allows air into the fuel tank to prevent vacuum when the fuel is being fed through the fuel line. Tip: if the vent is clogged, your engine may stall. Usually, the vent line is connected to a fuel grommet that is installed on the fuel tank. The tools needed for this installation are: needle-nose pliers and a small slotted screwdriver. Remember to wear work gloves to protect hands. Refer to the manual for an accurate repair guide.

Fuel Line Grommet This is a fuel line grommet, and it is used with various lawn and garden equipment. This part prevents leaking fuel and fumes. The grommet is placed in the fuel tank to seal the opening area where the fuel line and the fuel tank connect. A worn grommet is a safety hazard because it will cause fuel to leak from the tank. We recommend when replacing it to also replace the fuel line. Before starting this repair make sure to drain the fuel from the tank, and remove the spark plug.

Tune-Up Kit In order to keep your equipment running strong, doing regular maintenance is critical. Your small engine should have a tune-up once per year, which consists of replacing the most common wear parts. This OEM-sourced kit includes an air filter; spark plug and fuel filter. Replacing all the parts in this kit should not take any longer than five minutes. Start by installing the air filter. Remove the air filter cover and air filter. Place the new air filter on the filter case and place the cover back on. Next, replace the fuel filter. Remove the gas cap and use a wire hook to lift the fuel line from the tank. Remove the old filter and line up the new one onto the fuel line, making sure the retaining clamp fits over the nipple. Lastly, replace the spark plug by first removing the boot. Use a wrench to remove the spark plug. Before installing the new spark plug be sure to check the gap between the electrodes. Install the new spark plug into the cylinder and place the boot back on.

Fuel Return Tube 3x6x90mm This is a fuel return tube, for various lawn equipment. This part is yellow and is 90mm long. The tube is used to return the extra fuel back into the fuel tank. This happens after the primer bulb has primed the carburetor to start. Depending on usage, this part will weaken and crack, that is when you will need to replace it.

Filter, Fuel This is an OEM fuel filter and is sold individually. This repair is very easy and will only take a few minutes. It is also a very important maintenance task that should be done regularly. This part is located inside the fuel tank and filters out debris to prevent it from making its way to the carburetor. If you notice fuel is leaking or their seems to be blockage, your fuel filter is likely in need of a replacement.

Spark Plug Cap Spring