Chainsaw Carburetors

Fix Number

FIX9471212

Manufacturer Part Number

530047721

If your engine is having trouble starting, you may be in need a new purge bulb. When the engine has been sitting for a while, unused, the fuel will drain and eventually dissolve out of the carburetor. The next time you go to use your equipment, the engine will not start until the carburetor has fuel in it. The purge bulb, also commonly referred to as a primer bulb, manually pumps fuel back into the carburetor, while purging air out. If the purge bulb is malfunctioning, you will need to pull the starter rope numerous times until the carburetor diaphragm can pump the right amount of fuel back into carburetor for the engine to start. This purge bulb is prone to hardening and cracking over time because it is in continuous contact with fuel and will need to be replaced. This part is sourced directly from the manufacturer and sold individually.

Fix Number

FIX9472698

Manufacturer Part Number

530071835

This is a single OEM purge bulb, also sometimes referred to as a primer bulb. It is usually located close to the starter rope. By pressing down on the purge bulb, this forces fuel into the fuel line from the fuel tank and into the carburetor to help get the engine started. Due to its constant contact with fuel, the bulb is prone to damage over time and will need to be replaced.

Fix Number

FIX9482503

Manufacturer Part Number

545081885

Fix Number

FIX9482465

Manufacturer Part Number

545070601

This is an authentic replacement carburetor which is supplied by the original equipment manufacturer for use with Craftsman chainsaws. The purpose of this part is to mix the air and the gas before the combustible mix goes into the engine, if the engine won\\\'t start and the tank is full of fresh fuel or if the engine starts and then quickly dies, the carburetor is likely the problem. Please note this high-quality metal body component is sold individually, it includes the primer bulb. Zama W-26

Fix Number

FIX9472427

Manufacturer Part Number

530069844

This is a carburetor repair kit, but it may also be known as a carburetor gasket or diaphragm kit, for your lawn equipment. This assembly is used to replace the gaskets in your machine. If you are having problems with your carburetor, this kit most likely takes care of it. Note: The beige piece pictured has been redesigned. It no longer has the 4 corner holes. It now only has 2 corner holes at a diagonal. To replace these items, you will need a screwdriver and pliers.

★★★★★

★★★★★

1 Review

Fix Number

FIX9471324

Manufacturer Part Number

530049700

Fix Number

FIX16304860

Manufacturer Part Number

20001441

★★★★★

★★★★★

1 Review

Fix Number

FIX9261164

Manufacturer Part Number

12310037330

Fix Number

FIX11834391

Manufacturer Part Number

20001368

Fix Number

FIX10044036

Manufacturer Part Number

D10-WAT

This is a genuine OEM replacement part sourced directly from Walbro. If the engine in your lawn and garden equipment is running rough, the carbonator might need to be cleaned and rebuilt. This kit is commonly used for chainsaws, trimmers, leaf blowers, and edgers. Over time the carburetor gets dirty and parts begin to wear out, instead of replacing the carburetor you can replace the gaskets and diaphragms for increased performance. The kit includes all of the gaskets and diaphragms you will need to rebuild your 2-cycle engine carburetor. When the rebuild is complete be sure to check all connections before running, and while testing ensure there is only a small amount of fuel in the tank. To complete this job you will need a screwdriver and a pick.