Poulan Chainsaw Carburetors

Bulb-Purge "snap-in" If your engine is having trouble starting, you may be in need a new purge bulb. When the engine has been sitting for a while, unused, the fuel will drain and eventually dissolve out of the carburetor. The next time you go to use your equipment, the engine will not start until the carburetor has fuel in it. The purge bulb, also commonly referred to as a primer bulb, manually pumps fuel back into the carburetor, while purging air out. If the purge bulb is malfunctioning, you will need to pull the starter rope numerous times until the carburetor diaphragm can pump the right amount of fuel back into carburetor for the engine to start. This purge bulb is prone to hardening and cracking over time because it is in continuous contact with fuel and will need to be replaced. This part is sourced directly from the manufacturer and sold individually.

Primer Bulb Kit This is a single OEM purge bulb, also sometimes referred to as a primer bulb. It is usually located close to the starter rope. By pressing down on the purge bulb, this forces fuel into the fuel line from the fuel tank and into the carburetor to help get the engine started. Due to its constant contact with fuel, the bulb is prone to damage over time and will need to be replaced.

Carburetor This is an authentic replacement carburetor which is supplied by the original equipment manufacturer for use with Craftsman chainsaws. The purpose of this part is to mix the air and the gas before the combustible mix goes into the engine, if the engine won\\\'t start and the tank is full of fresh fuel or if the engine starts and then quickly dies, the carburetor is likely the problem. Please note this high-quality metal body component is sold individually, it includes the primer bulb. Zama W-26

Kit-Carburetor (Walbro-WT-89)

Carburetor Kit

Carburetor-W-29

Carburetor With Purge W47

Carburetor Repair Kit Walbro (WT324)

Kit-Carb. Kwik Repair