Ingersoll Rand Parts

Fix Number

FIX12096998

Manufacturer Part Number

RG1-A400

Fix Number

FIX12096683

Manufacturer Part Number

DG230-303

The valve seat goes between the housing assembly and the valve. This item is made out of plastic and is available individually. This is a genuine replacement part sourced from the original manufacturer for use with impact tools and impact wrenches made by Ingersoll Rand. When replacing this part an adjustable wrench might be required during the installation process. It will require replacing if it becomes broken.

Fix Number

FIX12096854

Manufacturer Part Number

MG1-339

Fix Number

FIX12096439

Manufacturer Part Number

529-274A

This collet assembly holds the blade firmly inside an air-powered reciprocating saw. It helps keep the blade connected to the tool as it moves back and forth during cutting. Replace the assembly if it is worn, damaged, or no longer holds the blade securely. A worn collet may cause the blade to feel loose or slip during use. Before starting the repair, disconnect the air hose and make sure the tool cannot turn on. Compare the replacement with the original part to confirm the correct shape and fit.

Fix Number

FIX12095242

Manufacturer Part Number

2135-425

The socket retainer fits between the ring and the pushing. This is made of metal and is available as an individual replacement part. It is a genuine item that is supplied by the original equipment manufacturer for use with Ingersoll Rand impact wrenches. A screwdriver may be helpful when replacing this part. It will need to be replaced if it becomes broken.

Fix Number

FIX16664476

Manufacturer Part Number

114G-11

An air tool that responds poorly when its trigger is pressed or released may have wear inside the throttle assembly. This replacement steel spring works with the throttle ball to support proper airflow control. Correct spring tension helps the throttle pieces move as designed, but the ball, seat, plunger, seals, and trigger should also be inspected. Clean the area and replace any damaged pieces found during service. Shut off the compressor supply, disconnect the air line, and press the trigger to release trapped pressure. Work over a clean surface so small pieces are not lost, and use the exploded parts diagram to confirm their order and direction.

Fix Number

FIX12094985

Manufacturer Part Number

131-666

This is a genuine OEM replacement part used with many impact wrenches. The reverse valve knob is fastened to the bushing in the motor housing assembly, assisting with the direction of the drill bit. This metal item is sold individually, and a hex key is often used for making the replacement.

Fix Number

FIX12096856

Manufacturer Part Number

MG1-42-4

This is an authentic component which is sourced directly from the original equipment manufacturer for use with Ingersoll Rand air grinders. This part is made of layered fabric and laminate and is used to spin the rotor. This part is designed to slowly wear down over time, to avoid damage to the cylinder. It is advisable to replace all the rotors at the same time for even wear. Keep in mind this high-quality vane is sold in a pack of four. Please make sure to check the appropriate diagrams of your model for the correct location and application of these parts.

Fix Number

FIX12095434

Manufacturer Part Number

230-36

Fix Number

FIX12094903

Manufacturer Part Number

117-A64

An air hammer that responds slowly or does not start when its trigger is pressed may have a worn throttle plunger assembly. This small moving assembly works inside the throttle valve to help control compressed air entering the tool. Check the hose, air pressure, trigger, seals, and nearby valve pieces before choosing a replacement. Confirm fit with the complete tool model because similar plungers may differ. Shut off and disconnect the air supply, then release stored pressure before service. Keep small springs and seals in order, use only the lubricant named in the service manual, and test the trigger carefully after reassembly.