Gibson Dehumidifier Parts

Shop By Appliance Type Shop By Part Type

Popular Gibson Dehumidifier Parts

CORD-ELECTRICAL SERVICE

$43.92

Fix Number: FIX432664
Manufacturer Part Number: 3015166

Air Filter

$61.55

Fix Number: FIX447882
Manufacturer Part Number: 327350601

KNOB-CONTROL

$27.28

Fix Number: FIX447856
Manufacturer Part Number: 327300704

Fan Blade

$78.55

Fix Number: FIX447941
Manufacturer Part Number: 327650104

Compressor Start Relay

$43.95

Fix Number: FIX426380
Manufacturer Part Number: 216594300

Fixes these symptoms

Too warm
Will Not Start
Won’t start
See more...

Installation Instructions

Scott from Watkins Glen, NY

Freezer stopped cooling

On the compressor are two components. The first is the start relay which allows voltage to pass through to the compressor when it's called to run by the thermostat. The second is the thermal override which protects the compressor by shutting it down when over heated. Both are plugged into the three compressor power prongs. Thermal is plugged into the top prong, starter relay to the two lower prongs. To start the repair, pull the two wire leads off of the components. Take a pair of needle nose pliers and gently pull out the starter relay. Next pull out the thermal override. Make sure the compressor windings aren't bad by testing the leads with an ohm meter. There are how to's on the web but basically place the ohm meter in its lowest setting and take a reading between the two bottom prongs. Write this number down. It should have a resistance of about 10.5 ohms. Next, take a reading between the top and bottom left prongs and then do the same on the right side. Add the left and right reading together and they should equal the initial reading that you took across the bottom prongs (10.5ohms) or so. If not, your compressor is the issue. If all tests out OK, replace the start relay in the reverse order of disassembly. The switchout takes all of 15 minutes to perform. Made my freezer like new. Read more...

EVAPORATOR

$145.62