Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim
September 21, 2021
How to replace/install part WPW10124269?
For model number KBMS1454RSS0
Hello Jim, Thank you for the question. To start make sure you unplug the appliance or disconnect power at the breaker. Remove the microwave oven from its mount if it is still mounted. Remove the T10 Torx screws from the top cover of the microwave, there should be approximately 11 screws. Lift the back of the cover, slide the spring tab out of the control panel slot, and remove the cover. Discharge the high voltage capacitor using a 20,000 O resistor from the terminals to chassis ground. Make sure this is done and properly to avoid a dangerous shock. Disconnect the 6 ribbon cable connectors from the user interface board. Unclip the user interface board from the holder and remove it from the appliance. Remove the two T20 Torx screws from the user interface board holder and remove the holder from the panel. Remove the four T20 Torx screws from the control panel assembly and remove the assembly. Place the control panel on your work surface. To remove the display, press out on the four holder clips, and pull the display out of the holder. Reinstall in reverse order. We hope this helps!
Was this helpful?
Thank you for voting!
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.