Felt Seal 4036EL3001A

Hello Robert, thank you for contacting us. We have researched the model and would suggest following these general instructions to disassemble your dryer: First, remove the top plate assembly by inserting a butter knife at each corner to push the tabs inside, which then releases the top assembly. Slightly push the butter knife upwards and take the top panel off. Next, to disassemble the front panel, remove the shutoff switch by holding it from the inside using a plier. Remove all the screws holding the front panel on the top and front side. Lift the door to disengage it from the door pegs. To get assess to the control panel, the top rear plate might need to be disassembled by removing the screws and wiring connections. We hope this information helps!

Hello Joe, Thank you for reaching out. This model shows 1 Felt Seal and 1 Drum Belt. Thank you for the inquiry, good luck with the repair!