Have you ever purchased from us before?
Thank you for helping make our site better.
Manufacturer #: WE12X83 /
Manufactured by: GE /
Fix #: FIX265721
Manufacturer #: WE12X83 |
Manufactured by: GE |
Fix #: FIX265721
I followed all the video on the website with all the parts I had purchased. Very easy. Just make sure you unplug the dryer first. Thank you,
Were these instructions helpful?
Look at the video you sent me .and did the same thing on vedio it was easy to do thanks a lot
If you are replacing the belt- I recommend to order the Idler pulley and Felt bushing for drum - UNPLUG DRYER- 1. Open door-remove 2 screws top corners, 2. Lift top of dryer up and out to remove, 3. Remove 4 front screws (2 each side near top) 4. Pull Front of dryer out and up- disconnect wires to door- 5. remove Left side panel (looking at front of dryer) by removing 5 screws in back. 6. Remove old belt, put new belt around drum from the front and slide to middle of drum and loop over drive motor. 8 replace Idler pulley, and push pulley so it catches the back of the belt loop and holds tension 9 Reinstall left side dryer panel 10 install felt on dryer front and reinstall (lift drum opening so it lines up with door 11 reinstall front - connect wires - install top and tighten all screws.. Plug in- done
Searched Internet for dryer model squeeking. Found probable cusses. Watched video. Took dryer apart found the above parts worn out. Changed the belt and idler pulley just because I had the dryer apart. Less than 50 minutes dryer is fixed. Dryer is like news for $133.00
Know the warning signs of a deteriorating asphalt roof! Making th…