Official Kenmore Washer Dryer Combo Valves

M Series New Style Coil Kit

$30.89

Fix Number: FIX334310
Manufacturer Part Number: 279834

This OEM kit comes with two ignition coils (one three-terminal boost/hold coil, and one two-terminal secondary coil). Usually only one of them burns out, but you should replace them as a set as both have to be operational for the gas valve to open. The primary purpose of the part is to open the gas valve and allow the gas to enter the burner. This is a safety mechanism to make sure that there is never an unsafe buildup of gas inside the appliance. You will find the coils attached to the dryer gas valve. This is not an uncommon repair; it can fail due to normal material fatigue over time. To test your current parts, watch the burner, and if the igniter glows for a while and then shuts off without the gas is igniting, it usually means one of these coils is bad.

Fixes these symptoms

Noisy
Not Heating
See more...

Watch the install video

Water Inlet Valve with Mounting Bracket

$35.28

★★★★★

2 Reviews

Fix Number: FIX334646
Manufacturer Part Number: 285805

There are many symptoms that may indicate an issue with your water inlet valve. These can include your washer not filling with water, it will not stop filling, the washer is leaking, or it is both filling and draining at the same time. You can test if your valve is faulty two different ways. The first is to disconnect the power while the washer fills, if water continues to fill the tub, then the valve should be replaced. The second way is to use a multimeter to test for continuity on the valve solenoids. If you do need to replace the water inlet valve, this is a genuine OEM part that has two ports and is compatible with half-inch ID hose. Before beginning your repair, please be sure to disconnect the power and water supply to your washing machine.

Fixes these symptoms

Leaking
No hot or cold water
Water Filling Issues
See more...

M Series Ignition Coil Kit

$21.45

Fix Number: FIX470049
Manufacturer Part Number: 5303931775

This coil ignition kit is used in dryers to open the gas valve when the dryer is on. This kit includes two coils. One is a two-wire secondary coil and the other is a three-wire booster coil. If your dryer does not heat or you notice heating inconsistencies, then the gas valve may be damaged and it is best to replace it to solve this problem. To repair, first release the two retaining clips that hold the top panel in place, then remove two screws that retain the front panel of the dryer cabinet. Next, pull the front panel forward and remember to disconnect the door switch. After accessing the gas coils, start removing the wires and unscrew the bracket that holds the coils. Remember to remove both the dual and main coil without removing the spacer. For more information on the kit and repair instructions, refer to diagram for a list of the parts.

Fixes these symptoms

Not Heating
See more...

Watch the install video

Water Inlet Valve

$127.65

Fix Number: FIX815509
Manufacturer Part Number: 134190200

This washing machine water inlet valve has two ports for water to enter.

Fixes these symptoms

Leaking
No hot or cold water
See more...

VALVE

$109.78

Fix Number: FIX11769643
Manufacturer Part Number: W10906602

Natural Gas Limiter

$31.58

Fix Number: FIX11743791
Manufacturer Part Number: WP694424

VALVE

$95.42

Fix Number: FIX11703547
Manufacturer Part Number: 137465101

Water Valve - 115V

$134.89

Fix Number: FIX815534
Manufacturer Part Number: 134211400

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Fixes these symptoms