Roper Trash Compactor Hardware

Drive Gear Kit This is a genuine OEM drive gear kit for your trash compactor. It includes the drive gear, pin spring, a retaining clip which is also known as a c-ring, ram stop, and the ram cam. The ram is used to compact the trash and if it is getting stuck, making excess noise, or is not stopping at the end of the cycle, then the drive gear may need to be replaced. Before beginning this repair, please be sure to disconnect the power supply to the trash compactor.

Screw, 8/18 x 3/8 This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the manufacturer for further repair guidance.

Screw - 8-18 x 1/2 Sold Individually.

Single Metallic Shoulder Screw - Size: 8-32 x 3\8" This is an authentic OEM replacement part. This shoulder screw is commonly used in the assembly of trash compactors. Most often is it found at the base of the container, which holds the trash that is being compacted. We recommend you refer to model specific diagrams for appropriate uses and applications. This screw is made of metal, and it is 8-31 x 3/8? in size. This replacement screw is sold individually. Before repairing your trash compactor make sure you unplug it.

Rotary Nut This is a genuine OEM replacement part. This switch nut is commonly used in the assembly of trash compactors. It can often be found holding the knob in place on the back of the appliance. However, due to the variety of uses for this part we recommend that you refer to model specific diagrams for exact placement and appropriate applications. This nut is made of metal, and it is sold individually. Make sure you unplug your trash compactor before you begin any repair work.

Nut This is a genuine OEM replacement part. This replacement nut is commonly used in the assembly of trash compactors. This nut is the roller wheel lock nut, it is what hold the wheel in place at the bottom of the frame. To install the nut you will need a wrench, you simply need to thread the nut onto the roller wheel shaft. This nut is made of metal, and it is sold individually.

Single Hex Head Screw Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw, Ground

Screw This screw is sold individually.

BEARING This is an authentic OEM replacement part. This bearing is commonly used in trash compactors. Most often they are found in the power screw assembly, which drives the ram that compacts the trash. We do recommend you refer to model specific diagrams for appropriate uses and applications. This bearing is sold individually. For safety reasons we recommend you unplug your trash compactor before beginning repairs.