KitchenAid Trash Compactor Parts
Find Parts Fast
Guaranteed Fit
Repair Videos
Popular KitchenAid Trash Compactor Parts
- Fix Number
- FIX334230
- Manufacturer Part Number
- 279570
Fixes these symptoms
- Door Pops Open
- Door won’t close
- Lid or door won’t close
- See more...
Installation Instructions
jeffrey from Brookhaven, PA
Dryer would run, but not heat
Needed it running quick, so no diagnostics. Ordered one of everything that could fix problem (plus a new door catch). Tipped it onto it's back & popped the bottom cover off. Element, thermal cutoff, thermistor, and fuse. were right in front and held by 2 screws each (don't drop them, don't ask). A little bit tight inside, but no big issue. vacuumed the inside, replaced everything (it was the Heating Element, by the way), slapped the cover on, and put it back in its spot. works like it was new. Yes, I unplugged it first. Remember! Safety Third!
Read more...
- Fix Number
- FIX1964579
- Manufacturer Part Number
- W10165295RP
- Fix Number
- FIX385132
- Manufacturer Part Number
- 72017
Installation Instructions
Al from Cape Coral, FL
No heat when trying to dry clothes .
Followed instructions on your videos. Everything went as planned and the dryer works like new....
Read more...
- Fix Number
- FIX398589
- Manufacturer Part Number
- 882699
Fixes these symptoms
- Compactor ram gets stuck
- Doesn’t stop at end of compacting cycle
- Drawer is hard to open and or close
- See more...
Installation Instructions
John from RUTHERFORD, NJ
Trash compactor ram was not working.
Watched the video and followed the directions step by step.
Read more...
- Fix Number
- FIX11747965
- Manufacturer Part Number
- WPW10001130
Installation Instructions
Margaret from McLeansville, NC
Washing Machine Out of Balance - Missing Leveling Feet
The was an extremely simple repair. Tilted the washer up, placed the nut on the level foot, inserted the leveling foot in the slot and voila! Done. Absolute easiest repair ever.
Read more...
- Fix Number
- FIX11747576
- Manufacturer Part Number
- WP9871800
Fixes these symptoms
- Won’t start
- Won’t stay on
- See more...
Installation Instructions
Ronald from MOVILLE, IA
Switch knob broke off with part of the switch tube still in place.
Used a Philips screw driver, inserted it into the broken portion of the switch tube, turned it left to clear the ear slots which hold it in place. It then popped out and aligned the new switch and inserted, then turned to on to hold the switch in place. Simple.
Read more...
- Fix Number
- FIX11747573
- Manufacturer Part Number
- WP9871602
Fixes these symptoms
- Drawer is hard to open and or close
- See more...
Installation Instructions
Ben from Howell, MI
Trash Compactor the drawer was very hard to open
In replacing the old partial rusted drawer slides had rusted screw with nuts that spun had to drill them out and replaced front larger bolt and nut the rear screw used a larger sheet metal screw. The wheels and bearing with on easy the instructions showed a modification to remove a tab for the different wheel assembly and installed just like the instructions. When done the drawer will slide out with just touch of your foot on open tab GREAT!! I was looking at buying a new compactor the repair saved me about 700 $. Thanks a lot. Never had a trash Compactor before this great and it keeps my puppy out of trash.
Read more...
- Fix Number
- FIX347819
- Manufacturer Part Number
- 350930
- Fix Number
- FIX382679
- Manufacturer Part Number
- 675382
Fixes these symptoms
- Doesn’t stop at end of compacting cycle
- Won’t start
- Won’t stay on
- See more...
Installation Instructions
Kenneth from New Tazewell, TN
Quit after 38 years. Suggested a switch (s) failure
Removed two screws on front panel which allowed panel to become easily reachable. Replacement of rotary switch kit very simple. Did not replace sectional switch at this time. Back in operation.
Read more...
- Fix Number
- FIX11744742
- Manufacturer Part Number
- WP777811
Fixes these symptoms
- Compactor ram gets stuck
- Doesn’t stop at end of compacting cycle
- Noisy
- See more...
Installation Instructions
Chad from Moreno Valley, CA
Trash Compactor would not stop after cycle and would make a ton of noise
I had a couple of problems with my trash compactor, it was present in the home when we bought it. First it wouldn't turn on, the on/off switch was broken so I replaced the switch and knob assembly. Then the unit would run through a cycle and wouldn't stop at the end and would make a loud banging noise. My directional switch was the suspect at first because it was in bad shape to begin with, looked like it had gotten stuck at some point and bent the arm. I replaced the directional switch and it didn't help. Then I realized that the on/off/start panel showed that the start button was stuck in the on position. This was delivering constant current and wouldn't allow the unit to stop. DON'T spend $150 for a new start/on/off panel. I took the panel off and separated the front from the back to expose the buttons from the inside. The start button was stuck so I took the parts out and reassembled them, they're all little plastic and metal pieces that interlink. After I reassembled the buttons' insides I reassembled the panel and reinstalled it. The unit works fine now.
Read more...