Range Seals and Gaskets

Lint Trap Housing Seal This genuine OEM part is a lint trap housing seal for your dryer. This part is used to form an airtight seal at the back of the dryer drum and the lint duct. The foam seal is approximately 28 inches in length, 1 inch wide, about half an inch thick, and has an adhesive backing. The seal is located between the lint duct and the bulkhead of the dryer. You may need to replace the seal if there is air leaking from the dryer while it is running, which would result in your laundry taking too long to dry.

Door Gasket This oven door gasket comes with built in retaining clips.

Range Oven Door Gasket The oven door gasket creates a seal between the oven door and the opening of the oven to prevent heat from escaping when the oven is closed.

Door Gasket This oven door gasket prevents heat from escaping the oven cavity when in use.

Oven Door Seal with Clips

★★★★★

★★★★★

(1)

Also known as gasket.

SEAL CNTL (Black)

Light Gasket This part creates a seal around the light lens and bulb.

SEAL

Door Gasket

★★★★★

★★★★★

(1)

Oven Door Gasket

★★★★★

★★★★★

(1)

This part is the replacement door gasket for your oven. It is made of gray rubber and is sold individually. The door gasket runs along the circumference of the oven door and creates a seal that insulates the oven and keeps heat in. If your oven will not heat up properly, or if you notice that the door gasket has become loose or worn, it may need to be replaced. To replace the door gasket, you will need to remove the retaining bracket at the bottom of the oven door, then carefully pull the gasket away from the front of the oven cavity. Then, push the new gasket inside the groove on the outside of the oven cavity, securing it with the arrowhead fasteners that are built in to the oven cavity. This is an OEM part from the manufacturer.