Select Your Amana Range Hood Model

This replacement light bulb is sold individually.

This is a screw and it is made for multiple appliances in your home. This model is called a sheet metal screw because it has sharp points, and the threads are closer together. This screw is designed to be driven directly into sheet metal or plastic. It measures to be less than 0.5 inches long, and requires a Phillips head screwdriver.

Sold individually.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the manufacturer for further repair guidance.

This screw is sold individually.

Part may differ in appearance, but functions same as original.

The top of this part is now black.

This metallic vent hood filter collects grease particles in the air from cooking. This filter is also removable for cleaning.

Sold individually.

This is an OEM part sourced directly from the manufacturer. This rocker switch is used a number of appliances, most often it is used in ranges, dishwashers, range hoods, wall ovens, and cooktops. He uses vary depending on appliance, but some common uses are to turn on oven lights and downdraft fans. In the case of ranges, and wall ovens it fits in the control panel and allowed you to turn the oven light on an off. Due to the mechanical nature and the fact this part is made out of plastic it may wear down over time, at which point it will need to be replaced. To replace this switch you first need to remove the control panel, you will then pull the connector off the back of the switch, make sure you attention to which is the top and which is the bottom, this will make installing the new switch easier. After the connector had been removed you can then push the old plastic rocker switch out of the hole, and pop the new switch into place. Then reconnect the wires, and reassemble the control panel. Before starting this repair make sure your appliance had been unplugged.