OEM Roper Freezer Parts | Expert DIY Repair Help & Fast Shipping

$54.68

Capacitor

★★★★★

2 Reviews

Fix Number FIX11757023

Manufacturer Part Number WPW10662129

The capacitor, also known as a run capacitor, is a component in your fridge that allows the compressor to cycle on and off to maintain a constant temperature. If your fridge and freezer are too warm it may be necessary to replace the capacitor. Other symptoms include an unusually noisy and overheated compressor. You can check the capacitor for continuity using a multimeter. This is a genuine OEM replacement part made of black plastic that measures 1 inch by 1.5 inches. When replacing this part, be sure to check the electrical contacts on the old capacitor. If they are corroded or burnt, you will need to replace the overload relay assembly as well. Be sure to disconnect the power supply to your refrigerator before beginning this repair.

Fixes these symptoms

Clicking sound
Freezer section too warm
Fridge and Freezer are too warm
See more...

Installation Instructions

Lisa from Yulee, FL

Both comparments very warm but fan working and lights on

Bought Capacitor, but I had to purchase Combo Start Up Kit that Cap goes into. The site said that 78% of the time my problem of both compartments being warm were resolved/repair by replacing Capacitor, but when the item was replaced it did not and my son looked further and found that it would then be the Combination Start Up Kit (Part# PS11740412), which starts the compressor. Thanks to this site the video used to install both parts. I was able to use the old Capacitor and I am returning the new one first purchased. Read more...

$6.04

Touch-Up Paint - White

Fix Number FIX385132

Manufacturer Part Number 72017

18ml

Installation Instructions

Al from Cape Coral, FL

No heat when trying to dry clothes .

Followed instructions on your videos. Everything went as planned and the dryer works like new.... Read more...

$30.55

Refrigerator Door Switch

★★★★★

3 Reviews

Fix Number FIX12728638

Manufacturer Part Number W11384469

Door switch turns the light off when you close the door.

Fixes these symptoms

Light not working
See more...

Installation Instructions

Marilyn from Dublin, OH

Light switch no longer worked

Turn off and unplug your refrigerator. I used the screwdriver on the left side of the part (where the plug is) and used the putty knife at the same time on the right side to push the spring lock portion of the part in. The part snapped out. I unplugged the left contact from the plug and put it on the new part, then I unplugged the right contact and put it on the new part. I did this so the wires would not go up into the refrigerator and be hard to find. I put the left side of the new part where the plug and contacts are in first then I snapped the right side in place. I plugged the refrigerator back in and it worked perfectly. Just take your time and gently remove and reconnect the new part. The store where I bought my refrigerator wanted $69.95 for a service call plus an hourly charge and part charge. Count on this site for your parts and do it yourself. I ordered the part on Monday, it was delivered on Tuesday around noon and I made the repair that afternoon. Read more...

$13.48

Freezer Door Key

Fix Number FIX11742410

Manufacturer Part Number WP4356840

Sold individually.

$22.00

Spray Paint - 12 oz. - White

Fix Number FIX347819

Manufacturer Part Number 350930

$55.82

Flat Style Oven Igniter Kit

Fix Number FIX1573892

Manufacturer Part Number 12400035

This flat style oven igniter kit is a genuine OEM replacement part for your gas range. When the igniter glows white hot, the heat opens the gas valve and ignites the fuel heating the burner assembly. If your igniter is only glowing orange or red, or not glowing at all, it will need to be replaced. This kit includes the igniter, ceramic wire nuts, an insulation pad, a metal bracket, and a variety of plug ends. This kit can be used for both short or long igniters, and the bake or broil element. However, it is not compatible with ranges that require round style igniters. The igniter has an amperage between 3.3 and 3.6. The element is very fragile and should be handled with care. Before beginning your repair be sure to disconnect both the power and gas supply to your range.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Gas smell
See more...

Installation Instructions

David from ENCINITAS, CA

Wall oven would take a very long time to ignite.

One of the 2 screws that holds the igniter to the burner assembly was stripped and difficult to get out. Other than that it was an easy fix. Read more...