Caloric Dishwasher Parts
Start With Your Model Number
Popular Caloric Dishwasher Parts
Heating Element Brass Nut
Fix Number FIX1524878
Manufacturer Part Number 154106202This heating element mounting nut is used in dishwashers and is used to hold the nut to prevent leaking. If your nut is damaged or you notice leaking from the dishwasher, then replacing this nut will solve this problem. The tools needed for this repair are a 1/2 inch wrench, 1/4 inch nut driver, and needle nose pliers. To repair, locate the two element heating nuts. Next, disconnect connecter wire and remove nut with wrench. Tip: when installing new nut, remember to add insulator sleeve back on. As a safety precaution, remember to disconnect the water supply line before beginning this installation. Also, unplug your dishwasher from the power source.
janet from Galena, MO
water leaking out bottomturned off power to dishwasher at the elec. panel. removed the "kickplate" off front bottom of dishwasher. leak was coming from where the heating element went thru tub. removed connector from bottom of heating element and brass nut practically fell off. it was cracked. ordered new brass nuts from this site it arrived quickly and installed it immediately. used a deep well socket to tighten the nut and leak was gone. Waaa Laaa!! Read more...
Fix Number FIX11751238
Manufacturer Part Number WPW10254672Used with some portable dishwashers and washers. NOTE: As per the factory, this is used for faucets with inside or outside threads. For female connection (outside) just remove the washers.
Fixes these symptoms
- Will not fill with water
- See more...
Saul from El Paso, TX
The connector to the faucet was not holding correctlySimply unscrew the old one and replace it with the new. All I needed was a pair of channel lock plyers. Read more...
Fix Number FIX11740613
Manufacturer Part Number WP285655This hose clamp is sold individually.
David from Middletown, PA
Slight leak in tub drain hoseUnplug unit from electrical outlet. Remove two Phillips screws in bottom of front cover. Swing front cover up and off the washer. Loosen both hose clamps. Place a large rag (or several paper towels) around base of hose where it connects to the water pump. Gently loosen bottom of hose from water pump and remove. Gently loosen top of hose from tub drain and remove. Slide new hose top onto tub drain. Slip both new clamps onto hose (lower clamp screw should be on the inside of the hose so that there is no interference with rotating parts). Slide new hose bottom onto water pump. Tighten both clamps snuggly. Re-install front cover. Plug unit back in. Read more...
Fix Number FIX11746842
Manufacturer Part Number WP910218
Dan from Hope, KS
dishwasher leaks at faucet coupler.R&R coupler gasket in coupler. be sure all surfaces are clean and new gasket is facing right direction. lubricate with petroleum jelly. be sure rubber washer in faucet adapter shows above end of adapter. should fix leaks at faucet. Read more...
Faucet Adapter Coupling
Fix Number FIX7321390
Manufacturer Part Number 5304490369This part connects the drain hose to the sink.
Dishwasher Door Spring
Fix Number FIX452144
Manufacturer Part Number 5300808971Sold Individually. Suggested to replace both at the same time.