ITW4871FW2 Whirlpool Washer - Parts

This part goes on the agitator retaining bolt.

This 6-pin shift actuator controls the washer’s transmission, allowing it to switch between agitating and spinning. It’s a common fix for washers that won’t spin, get stuck mid-cycle, or make odd nois...

This insert is sold individually. Knob not included. Knob is sold separately.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This hose clamp is sold individually.

This is the cap for your agitator.

This drive block connects the spin basket to the drive shaft in large-capacity washers, allowing proper spinning during cycles. At 2-5/16 inches high, it’s easy to install with basic tools. Replace if...

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

The drain hose carries used water from the washer to your house drain.

This white clothes mover is designed for the upper portion of the agitator.

This is the bearing for the lid hinge. Sold individually.