3LSR5233AW0 Whirlpool Washer - Parts

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shakin...

This is used in your direct drive washer that has a neutral drain.

This kit comes with the clamps.

Sold individually. NOTE: The color on the screw may not be the same as the image, but will still function the same.

This hose clamp is sold individually.

This is the cap for your agitator.

This is a pack of three suspension pads for your washer. The suspension pads in your washer are found underneath the tub and prevent the rotating metal parts from grinding on one another. If your susp...

This drive block connects the spin basket to the drive shaft in large-capacity washers, allowing proper spinning during cycles. At 2-5/16 inches high, it’s easy to install with basic tools. Replace if...

This part is used to activate the lid switch when the lid opens/closes.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This part is the replacement water inlet hose for your washer. It is black in color, made of plastic, and is approximately 19 inches long. The water inlet hose connects the water inlet valve to the wa...

This kit comes with springs, hardware, and brake lining.