GHW9100LW1 Whirlpool Washer - Instructions

I used a phillips head screw driver, however the heads of the screws were not phillips head, they were some other kind of head I have never seen.

Unscrewed two philips head screws, took off old handle and replaced with new. Fastened with two philips head screws. Took 60 seconds from start to finish.

The difficult part was getting the water from the washer without making a huge mess. I used a shop vac loosened the cover on the filter/strainer assembly use the shop vac to suck up the water before spills all over. if the tub is full I dumped my shop vac twice total. 1 Remove pedestal drawer 2 removed lower cover to expose mechanicals and pump assembly 3 vac out the water by using above procedure. 4 rotate hose clamps to a position where you can get the needle vice grip on them/remove hose clamps. 5 lift cover exposing electrical connections on the pump assembly depress tab slide connector out. 6 remove 1 torx head screw securing pump to base of washer. 7 remove pump assembly. 8 Reinstall in reverse of above instruction. I also took the lower tub hose off and washed, bleached along with hot water to. clean it

The handle is set with two screws (that don't come with the replacement handle so make sure to save them when you take the old handle off). They use the 6 point screwdriver but a regular flathead screwdriver will work - a phillips won't. Take the old screws out, put the new handle on and screw it back in using the old screws. EASY

I followed the online videos and did the install in about 10 minutes. I did not need to drill a new hole for my particular model as others have needed. It was a basic take the old valve unit out and install the new one.

I am a 70 year female - went online to order the part - it arrived a day later - it was absolutely a breeze to repair - I unscrewed the old cracked handle in about two minutes and screwed the new one in in about 2 minutes or less. It couldn't have been easier. I was so pleased that I saved time and money and I could do it myself. The cost of the part was much less than I would have paid at Whirlpool and my labor was free. Thank you Parts Select for making the part available.

Unplug electric. Open door. Peel rubber bladder back from washer door seal enough to expose wire retension ring. Remove three screws that hold door latch. Remove latch. Remove three wire harnesses. With new latch, reattach wire harnesses. Insert latch. Secure to machine with the three screws. Refit door seal and secure with retension ring. Plug in electric. Done.

Simple Install. Align stubs on handle with slots in dispenser. Snap in place and replace dispenser on rollers.. Took less than 15 minutes and no tools.

Had to open the panels, remove the old drain pump and install the new one. Remember if there is water still in the hose to either take it out with a wet/dry vacuum or put towels under neither to sook the water. 15 minutes of work and your done.

I saw a u tube video and followed the presenters instructions. Very simple instruction very simple repair. The whirlpool duet is a well designed machine with the mechanical parts easily accessible. I know if if would have had a professional service come and repair if it would have cost several hundred dollars. It cost me the parts, $50. 00 (That was for the 3-pack of baffles), 1 beer and my time. "Easy fix".