A25CS Maytag Washer - Parts

This one-speed, 120-volt drive motor is designed for use in top-load washing machines and plays a critical role in operating the wash basket and drain pump. It powers the spinning and agitating functi...

This injector tube is a little over two inches long. It it white and made of plastic.

This part aids in the spinning or agitating cycles.

This transmission lip seal repair kit comes in two pieces: a red four inch long piece, and a black one inch long piece. Both pieces are made entirely of plastic. This repair kit comes with and instruc...

This screw is sold individually.

This hose connects the washer tub to the drain pump, allowing water to flow out during the drain cycle. It’s a durable replacement for a cracked or clogged hose and helps prevent leaks and drainage issues.

This inner tub clamping nut is just under three inches in diameter, and is made of metal. It has a reverse thread and screws onto the mounting stem.

This outer tub clamp seal is sixty-eight inches long. It is black and made of rubber.

12-14 X 5/8. Sold individually. Your appliance will most likely require 4.

This shaft seal comes filled with grease on the inside, and is used for washing machines.

This lid switch actuator spring is exactly one inch long. It is made of metal.

This screw is sold individually.