A308 Maytag Washer - Parts

This part is located near the tub's brake assembly.

This washing machine injector hose runs from your washer's inlet to its injector. It is black and made of rubber. It is also available in an injector kit.

This is a set of 2 tension springs.

This clip is designed to hold a timer knob in place.

10 - 16 x .375

This one-speed, 120-volt drive motor is designed for use in top-load washing machines and plays a critical role in operating the wash basket and drain pump. It powers the spinning and agitating functi...

This Injector hose seal is sold individually. The injector hose is no longer available.

This part aids in the spinning or agitating cycles.

This screw is sold individually.

This timer knob spring is almost an inch and a half long, and is not quite an inch in diameter. It is made of metal and is used with the timer knobs of both washers and dryers.

This inner tub clamping nut is just under three inches in diameter, and is made of metal. It has a reverse thread and screws onto the mounting stem.