MAH3000BGW Maytag Washer - Parts

This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.

Sold individually.

Also known as the door boot seal. This part includes the drain and plug. The seal is located around the door of the washer to prevent water from leaking.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

This timer knob is not quite three inches in diameter. It is all gray in color and it is made entirely of plastic. This has a D-Shaped Shaft.

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

Sold Individually.

This kit comes with grease, earlier lip seal, revised lip seal, o-ring, seal tool, and washer kit. Used primarily on front load washers. NOTE: Bearing is NOT sold separately. It is only available ...

This foot pad is just over an inch in diameter. It is made entirely of rubber and is gray in color. This pad is intended for use with washers and some dryers.

This timer knob insert cap is just over two inches in diameter. It is all white in color and is made of plastic.

This dispenser door retaining pin is less than one inch long. Sold individually.

This kit contains a flat drive belt, two motor isolators, and an instructions sheet. The drive belt is made to slip on the pulley until the basket gets up the desired speed.